Prolong Your Rocktube™ Mini - Azustar RockTube Mini User Manual

3. If your device supports Bluetooth® 2.1, you will not need to enter the pairing code
manually.
(Remarks: After successful connection, the blue LED will flash and later flash once every
5 seconds. If the pairing has failed, LEDs will flash alternately. Repeat steps to re-pair.)
Prolong Your RockTube™ Mini
Your RockTube™ Mini Bluetooth® speaker is powered by a rechargeable battery. To
prolong the life of your battery, disconnect it from the charging circuit as overcharging
shortens the battery life.
Your RockTube™ Mini battery will achieve its best performance after two to three
complete charge and discharge cycles. For best performance, keep your RockTube™
Mini between 15-25°C. The battery performance will be limited in an environment well
below freezing temperatures. Battery capacity and lifetime will be affected if left in hot
or cold places.
Battery charging and low-voltage alert
When connected normally to charge, the red LED is on when charging and turns off when
charging is complete. This takes 2-3 hours.
When the battery is running low, the alert tone sounds once every 30 seconds and the red
LED flashes. Charge as soon as possible or it will automatically shut down in 5-10
minutes.
Remarks
1.During the pairing mode which lasts 3 minutes. other mobile phones or devices cannot
search out RockTube™ Mini.
2.Automatic reconnection can happen in the two cases:
a. If RockTube™ Mini is turned off, it will connected to the pre-set device automatically
when turned on manually.
b.When RockTube™ Mini disconnects from the device due to an exceeded effective range
(normally < 10 metres), it will re-connect to your device if it is back in the effective range
within 10 minutes.
3.Supports Bluetooth® 2.1 (There is no need to enter the pairing code manually if tested
with Bluetooth® 2.1 dongle.)