Screen Console - Mopar DVD REAR SEAT VIDEO SYSTEM Installation Instructions Manual

Mounting
Bracket
Overhead
Harness
Screen
Console
K6859241
3) Plug 12-way power harness connector and 16-way
Overhead
Harness
4) Fully engage the DVD bracket's two hook tabs to
Power
5) Snap four retaining clips on the DVD bracket into
Harness
DVD Player
Assembly
6) Plug and lock overhead harness connector into
7) Snap four retaining clips on the top of screen con-
8) Open the screen and carefully remove the
9) Peel and stick mercury warning label (Item 16) to
F – Finalize Installation and Perform Operation Test:
1) Re-install all previously removed components,
2) Re-connect the vehicle's battery.
3) Place supplied batteries (Item 17) into both head-
4) Place batteries into DVD remote.
11/09/2004
overhead harness connector into the back of DVD
player.
the floor console bottom mounting slots.
the floor console mounting slots. Make sure the
harnesses are not pinched or crimped.
the screen console (Item 14).
sole into the mounting bracket slots.
attached DVD remote (Item 15).
lower portion of forward facing surface of the left
(driver's side) B-pillar.
panels, and fasteners.
phones (Item 18) as shown.
Page 9 of 10