Page 1
3000 NSTRUCTIONS ANUAL Cemb 3000 Single phase Instructions manual (UK) Warranty (UK) Read the following instructions carefully before connecting the rectifier to the supply line and to the battery. - 1 - . N.0_M 13_10_08 ELEASE...
3000 NSTRUCTIONS ANUAL Cemb 3000 Battery Charger Versions: Single_Phase All battery chargers Cemb 3000 are conform to the following European standard DIN 41772-3-4 “Charging method and curve of transformers”. EN 60335–2-29 “Safety of electrical appliances and similar”. EN 55014 “E.M.C. standards”.
Page 4
Obligations of the “USER” : conforming to the operating instructions, the “USER” is any natural or juridical person using directly Powergen srl battery chargers or anyone using them for account of the above mentioned person.
3000 NSTRUCTIONS ANUAL 1. INSTALLATION q The installation environment shall be capable of ensuring the user’s safety and the conditions for a correct operation q Processor battery charger is exclusively designed to recharge traction batteries and each unit is assigned to a specific battery. q Processor battery charger has IP 20 protection degree, therefore it shall be protected from rain and water sprays.
3000 NSTRUCTIONS ANUAL 4. MAINTENANCE q No scheduled maintenance is provided, though control and cleaning inspections may be performed within the battery charger system depending on its work environment. However such operations shall only be carried out by qualified staff. q Any maintenance intervention shall only be carried out after disconnecting the rectifier from mains and from the battery.
3000 NSTRUCTIONS ANUAL 5. OPERATION LED 1 (yellow) Battery connected LED 2 (yellow) Initial charge. The charge starts and the voltage per cell is lower than 2.4V. LED 3 (yellow) Final charge. Shows that the voltage per cell has exceeded 2.4V. The charging process continues for 3/4 hours and at the end of this time the charge iscompleted and the remote control switch will be placed in quiescent position.
The warranty is void due to improper use, incorrect installation or tampering q The warranty is void if interventions on the equipment are performed by persons not qualified by Powergen S.r.l. - 8 - . N.0_M 13_10_08 ELEASE...
3000 NSTRUCTIONS ANUAL 6.1 PROBLEM – SOLUTIONS AND CHECKS PROBLEM SOLUTIONS AND CHECKS Check the battery connection Make sure the battery voltage is suitable for the battery charger voltage The battery charger is not starting Check the efficiency of the d.c. fuse on the output Make sure the three phases are present in the line voltage Check the supply voltage.
3000 NSTRUCTIONS ANUAL 7. REQUEST OF SPARE PARTS AND/OR SERVICE REQUEST q We recommend to always advise the serial number of the battery charger. 8.TECHNICAL NOTE: These charging systems are capable of charging the battery either with the Wa characteristic according to DIN41774 standard (see table “one charging stage only”) or, alternatively, when the charging time needs to be reduced, according to the WoWa characteristic, based on DIN 41774 standard, see table “Addition of a second charging stage”.
3000 NSTRUCTIONS ANUAL WARRANTY CERTIFICATE Powergenprocessor ________________ Serial No. ____________________________ Customer’s stamp and signature Fill in and send to: - 11 - . N.0_M 13_10_08 ELEASE...
Page 12
3000 NSTRUCTIONS ANUAL Thank you very much for chosing our product. Congratulations on your decision. This equipment is the result of the most advanced technology and has been manufactured according to the most rigorous quality criteria. WARRANTY RULES 1. The purchaser shall fill in and send the coupon in order to be entitled to the warranty.
Need help?
Do you have a question about the CEMB 3000 and is the answer not in the manual?
Questions and answers