Threading The Machine - Piedmont KD-3 Instructions For Use Manual

m
ine
M
Turn Balance Wheel
towards you until the
take-up lever is raised to
its highest point. Place
spool of thread on the
spool pin of the machine
arm; pass thread through
the thread guide (A) at
the top corner of the
faceplate, down and over
the back to front bet-
ween the tension-disc (B),
up to over thread guard
(E), down into the hook
of take-up spring (C),
and over back to front
through hole in the end
of the thread take-up-
lever ( F ) , down into the
eyelet of the face-plate
(G), into the lower wire-
thread guide ( H ) , then
from left to right through
eye of the needle ( I ) .
Draw about 5" of thread
through the eye of the needle with which to com-
mence sewing.
Hold the end of needl ethread in your left hand, turn
balance wheel towards you until needle moves up and
down, and up again to its highest point, catching the
bobbin thread, which will be brought up that way
through the hole in the needle plate.