Headset Registration - HME HS6000 Operating Instructions Manual

Headset Registration

Each HS6000 Headset must be registered for use with a specific base station. The base station thereby
recognizes all headsets registered to it when their power is on, and will be able to tell the difference between
them and other electronic equipment operating on similar frequencies. A maximum of 15 headsets can be
registered. If one is replaced, you must register the new one before you use it. When a headset is replaced, the
old one remains in memory. If the maximum number of 15 is exceeded, you must clear all current registrations
and re-register all active headsets. To clear all current registrations, open the base station and press the CLEAR
ALL REGISTRATION button and the RESET button at the same time. Refer to Figure 4. Continue holding the
CLEAR ALL REGISTRATION button after releasing the RESET button, until the clear code "c" (lower case)
appears on the Communicator ID display. Register all active HS6000s the same way, one at a time.
NOTE: Headsets must be within 6 feet (1.83 meters) of the base station while being registered.
Wireless IQ
If your base station looks like this
registration instructions
see
™
For Wireless IQ Audio Systems, Register each Headset as follows:
•
Be certain all headsets to be registered are turned off and the base station power is on. Other
headsets can be on or off.
•
Open the base station and locate the items shown in Figure 4.
⎯ If no headsets are on, the status light will be blinking red. If any headsets are on, the status
light will be on steady green.
⎯ Press the START REGISTRATION button. The Communicator ID display will show a small
"o" for open, and the status light will be blinking green.
•
Press and hold the B button while pressing and releasing the power button to turn the headset
on, and release the B button. This will cause the headset to enter the registration mode.
⎯ The status light in the base station will be blinking green and the Communicator ID display will
continue to show a small "o" for open.
⎯ The power light on the headset will be blinking red then will change to green.
When the registration is
successfully completed:
•
The green status light in the base
station will be on steady and the
Communicator ID display will show
the ID number assigned to this headset.
ID numbers are assigned sequentially
as 0 thru 9, A, b, C, d and E.
•
The power light on the headset will
remain on steady green.
If registration failed:
•
A message in the headset will say "Beltpac #, Battery Low/Half/Full, Registration ..." The power
light will blink red and after a delay of up to 1.5 minutes you will hear "Registration failed."
•
Note the condition of the STATUS light in the base station. Press the RESET button. The STATUS
light may blink and change colors. When the STATUS light returns to its previous condition, press
the START REGISTRATION button and repeat the registration procedure.
•
If the registration fails again - In the USA call HME Customer Support at 1-800-848-4468.
™ base station
below
Figure 3. Wireless IQ
Outside the USA, call your local HME representative for help.
ionIQ
If your base station looks like this
see registration instructions on page 3
™ and ionIQ ™ base stations
Communicator ID display
K1 switch
RESET button Status light
Figure 4. Registration buttons and indicators in base station
2
™ base station
CLEAR ALL REGISTRATION button
START REGISTRATION button