1. Manuals
  2. Brands
  3. Ramco Manuals
  4. Saw
  5. RS90 Series
  6. Instruction manual and illustrated parts breakdown

Ramco RS90 Series Instruction Manual And Illustrated Parts Breakdown

Cutoff saw
Hide thumbs
Table of Contents

Advertisement

Quick Links

105.4" Blade [Carolina Bandsaw]

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RS90 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Ramco RS90 Series

  • Page 1 105.4" Blade [Carolina Bandsaw]...

  • Page 2: Table Of Contents

    Index Section 1. General Information Page 2 Section 2. Inspection Page 2 Section 3. Location of Installation Page 2 Section 4. Cleanliness Page 2 Section 5. Installation Page 2 Section 6. Safety Precautions Page 2 Section 7. Lubrication Page 2 Section 8.

  • Page 3: General Information

    6.8 This tool should be grounded while in use to protect the operator Section 1: General Information from electric shock. Replace or repair damaged or worn cord You have purchased a quality machine tool, and you will want to give immediately.

  • Page 4: Cutting Speed Chart

    V-BELT in the SMALLEST pulley groove of the MOTOR PULLEY thereby tightening the saw blade just enough to track align itself. (Item 7) and in the LARGEST pulley groove of the REDUCER 13.3 Check to be sure that the blade is properly installed and freely PULLEY (Item 5).

  • Page 5: Adjusting The Clamp Vise

    material, adjust the blade pitch outward. cutting. If the blade is cutting “out” at the bottom of the stock material, adjust Section 20: Horizontal Operation the blade pitch inward. 20.1 Raise the saw head so that the saw blade clears the stock 16.3 Re-tighten the blade guide mounting bolts.

  • Page 6: Raising The Saw Head To Vertical Position

    Section 22: Raising the Saw Head to Vertical Position to be made, and do them all in the same set up. 22.1 Loosen the LOCKING BOLT (ITEM 35). Section 26: Important Notes 22.2 EXTEND THE VERTICAL SUPPORT LEG (Item 36) The BLADE GUIDE BEARING adjustments outlined in about 6”.

  • Page 7: Trouble Shooting

    Section 27: Trouble Shooting Problem Probable Cause Solution Excessive Material loose in vise. Clamp work securely. Blade Wrong speed or feed. Check machininst handbook for correct Breakage speed and feed. Teeth too coarse for stock. Check machinist handbook for Wrong blade tension. recommended blade type.

  • Page 8: Parts List

    Section 27: Trouble Shooting Problem Probable Cause Solution Teeth Blade too coarse for stock. Use finer tooth blade. Ripping Heavy feed; slow feed. Decrease feed pressure and/or increase feed. From Vibrating work piece. Clamp work securely. Blade Blade gullets loading. Use coarser blade or brush, to remove chips.
  • Page 9 Section 28: Parts List Item Part Number Descripton 33.2. P-2102 Saw Blade, 8 T.P.l. 33.3 P-2103 Saw Blade, 10 T.P.l. 33.4 P-2104 Saw Blade, 14 T.P.l. 33.5 P-2105 Saw Blade, 18 T.P.l. D-2163 Back Panel P-0102-29 Hex Head Cap Screw, 3/8-16 thread x 3/4 long B-2187 Vertical Support Leg...

Table of Contents

Save PDF