3-1. Alarm Display
This unit has an alarm display function.
When a problem is detected, an alarm is displayed immediately in the time counter display. The alarm
and a message describing the countermeasure are displayed on the monitor area in the LCD and a video
monitor connected to the CPST (SUPER) connector.
This unit has two types of alarms : one is for operators while the other is for service persons. This
manual describes only the alarms for service persons. For details of alarms for operators, refer to the
operating instruction. Activating the alarm display may influence the system, such as when the reference
video signal is not used. Therefore, you can select whether or not to display the alarm from the Setup
menu selection. As for Setup menu, refer to the operating instruction.
However, the alarms for service persons are displayed regardless of the Setup menu setting.
3-1-1. Alarm Display when the Main Power is
Turned On
Detection :
Operation after detection : None
Display :
Detection :
Operation after detection : The Setup menu operates
Display :
HVR-1500
Section 3
Error Messages
The cassette compartment is
not attached, or the harness is
not connected to the cassette
compartment.
The alarm is displayed until
any key is pressed.
Checks the version of the
Setup menu.
using the factory settings. The
contents of the non-volatile
memory (EEPROM) remain
unchanged. Therefore, if the
setting of the Setup menu is
not changed, the same alarm
will appear when the main
power is turned on.
The alarm is displayed until
any key is pressed.
ALARM
THE SETUP MENU SOFTWARE
HAS BEEN UPGRADED.
SET THE SETUP MENU I TEMS
TO THE DES I RED SETT I NGS
OR ACT I VATE THE ' LOAD
MENU DATA ' (MA I NTENANCE
MENU) FUNCT I ON.
3-1