Troubleshooting - JVC 0497OFYOTKJEMEN Instructions Manual

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact
your JVC service center.
PROBLEM POSSIBLE CAUSE
The display does not light up The power cord is not plugged in
or the
pressed to set in the —OFF position
No sound from speakers Speaker signal cables are not
connected
The SPEAKERS 1 and 2 are not
set correctly
An incorrect source is selected
Sound from one speaker only Speaker signal cables are not
connected properly
The balance is set to one extreme
Continuous hiss or buzzing Incoming signal is too weak
during FM reception
The station is too far away
An incorrect antenna is used
Antennas are not connected
properly
Occasional cracking noise Ignition noise from automobiles
during FM reception
Howling during record Your turntable is too close to
playing speakers
Remote control does not There is an obstruction in front of
work the remote sensor on the receiver
Batteries are weak
SOLUTION
Plug the power cord into an AC outlet
POWER switch is
and press
_ON position
Check speaker wiring and
reconnect if necessary
Press SPEAKERS 1 and 2 correctly
Select the correct source
Check speaker wiring and reconnect if
necessary
Adjust the balance properly (see page
13)
Connect an outside FM antenna or
contact your dealer
Select a new station
Check with your dealer to be sure you
have the correct antenna
Check connections
Move the antenna farther from
automobile traffic
Move speakers away from the turntable
Remove the obstruction
Replace batteries
POWER to set it in the
Page 34