High Beam Headlight Adjustment; Lower Headlamp Removal / Installation - Polaris A12MH46AX Service Manual

ELECTRICAL
5 1/8" (13 cm)
NOTE: The distance from the headlamp parting line
to the end of the adjustment knob stop is 5 1/8", (13
cm). See illustration.
9. Adjust the headlight aim by turning the adjusting knob.

High Beam Headlight Adjustment

The headlight beam can be adjusted to any position
desired by turning the adjusting knob located on the
bottom right side of the headlight pod.
Raise Headlight
counterclockwise
Lower Headlight - Turn knob clockwise
10.32
- Turn knob counter-
HIGH
LOW
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.
1. Place the vehicle on a level surface with the headlight
approximately 25' (7.6 m) from a wall.
25' (7.6 m)
Lamp Center Height
2" (5.1 cm)
2. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the same
height.
3. Start the engine and turn the headlight switch to high
beam.
4. Observe headlight aim. The most intense part of the
headlight beam should be aimed 2" (5.1 cm) below the
mark placed on the wall in Step 2.
NOTE: Rider weight must be included on the seat.
On machines with separate low beam lights, the
drop should be 8, (20.3 cm) in 25' from the center of
the low beam lamp.
5. Adjust beam to desired position.

Lower Headlamp Removal / Installation

Remove Install