Table of Contents
Advertisement
Learn Setup from Master STB
1. Ensure the Master STB is set up completely and in Pass-through Mode
(i.e., the STB setup menus should be displayed on the screen when you
press MENU on the Installer Remote).
2. Insert the USB memory device into either of the USB ports on the Master
STB.
3. Press MENU on the Installer Remote to display the STB setup menus.
Use the arrow navigation keys to select/highlight the Option menu icon,
and then press the number "7" key a total of seven times to display the
USB Download Menu.
4. To gain access to the "Learn From STB" options in the USB Download
Menu, key in the following number sequence on the Installer Remote:
9-8-7-6.
5. Use the Up/Down arrow keys to select Learn From STB (TLX), and then
press OK.
6. In the Learn From STB (TLX) window, to differentiate this TLX file from
others, you can use the Up/Down arrow keys to change the last five digits
of the filename. Press OK when you are ready to initiate Learning.
Learning status will be shown on a progress bar in a new window. Do NOT
remove the USB device until Learning is complete. When the Learning
process is complete, the USB Download menu will reappear on the screen.
7. When Learning is done, press
Download Menu, and remove the USB memory device from the Master
STB.
Teach Master STB Setup to Target STB
1. Turn ON the Target STB/display panel.
2. The next step depends on whether the EZ-Manager Wizard appears on
the screen when you turn ON the STB/display:
• If the wizard is displayed, the STB is in the required factory default state.
To continue with this procedure (see also note below), exit the wizard,
and then continue with step 3.
• If the wizard is not displayed, restore the STB to a factory default
condition before continuing with this procedure. See Reference section,
"Restoring Factory Defaults on the STB(s)," as necessary, for further
information.
Note: If desired, you can complete the Teaching process via the EZ-
Manager Wizard (see "USB Configuration" on pages 21 to 22) or using
the LG Smart Install utility (see "LG Smart Install Utility" on pages 23 to 24).
206-4256
on the Installer Remote to exit the USB
Cloning Procedures (Cont.)
USB Download Menu
Upgrade STB Software
Upgrade PTC Software
Diagnostics
Teach To STB (TLL)
Teach To STB (TLX)
Learn From STB (TLL)
Learn From STB (TLX)
Previous
Note: The Diagnostics option in
this menu is for service use only.
Learn From STB (TLX)
Select the file name and press OK to start
STB-2000-UA00003.TLX
Previous
Learn From STB
UPDATING...
Do not unplug!
OK
V
OK
25%
(Continued on next page)
41
Advertisement
Table of Contents
