Sea-doo RX DI 5646 Operator's Manual page 27

Resetting a Function
To reset a function (such as the chro-
nometer, peak speed, distance, etc.,)
press and hold the SET button for 2
seconds while in the appropriate mode.
The information center includes the
following display areas.
1. General display
2. Message/units display
3. Warning light
4. Fuel level display
5. VTS position indicator (if so equipped)
General Display
The default display is the clock (or
clock/compass if so equipped) unless
another mode has been selected. See
Display Priorities below.
Repeatedly pressing the MODE button
scrolls the following displays: Tachom-
eter, speedometer, peak speed, aver-
age speed, trip meter, hourmeter, wa-
ter temperature, exterior temperature
(if so equipped) and chronometer.
1. Press to change display mode
When you are satisfied with your choice,
stop pressing the button.
Clock: Indicates the actual time in hours
and minutes (hh:mm).
Clock/Compass (if so equipped): Dis-
plays the cardinal points to indicate the
orientation of the watercraft.
Use the compass as a guide only.
Not to be used for navigation pur-
poses.
Tachometer: Indicates the revolutions
per minute (RPM) of the engine.
Speedometer: Indicates the speed of
watercraft in kilometers per hour (KPH)
or miles per hour (MPH).
Peak Speed: Indicates the top speed
the watercraft reached (PK KPH or PK
MPH).
Average Speed: The information cen-
ter approximately calculates and dis-
plays the average speed (AV KPH or
AV MPH) of the watercraft since the
last engine start.
Trip Meter: The information center ap-
proximately calculates the distance
based on the operation time and the wa-
tercraft speed and displays the result in
kilometers (KM) or miles (MILES).
Hourmeter: Displays the time in hours
of the watercraft usage.
Water Temperature: Displays the wa-
ter temperature (L TEMP) in degrees
Celsius (°C) or Farenheit (°F).
Exterior Temperature (if so equipped):
Displays the exterior air temperature
(E TEMP) in degrees Celsius (°C) or Fahr-
enheit (°F).
Chronometer: Allows to measure an
interval of time in hours and minutes
(hh:mm).
www.SeaDooManuals.net
WARNING
25