Carburetor Choke - Honda 1984 Shadow VT700C Manual

M AI NTEN A NCE
CARBURETOR CHOKE
Th is model choke system uses a fuel enrichening
circuit controlled by a bystarter valve. The bystarter
valve opens the enrichening circuit via a cable when
the choke lever on the handlebar is pushed up.
Check for smooth upper choke lever operation.
Lubricate the choke cable if the operation is not
smooth.
Remove the choke cable boots and loosen the choke
valve nuts on the carbure t ors.
Remove the choke valve from the carburetor.
Push the choke lever on the handlebar all the way
down to fully closed and make sure the distance
between the nut's th-raads and valve is 10- 11 mm
(0,39- 0.43
in) .
Adjust within sped fictions by loosening the lock
nut and turning the cable's elbow at the clutch
housing. Tighten the lock nut. Recheck the dis-
ta nce.
Thread the choke valve in by hand and then tighten
the choke valve nut 1/4 turn with a 14 mm wrench.
Install the choke cable boots.
Reinstall the removed parts in the reverse o rder of
disassembly.
3-6
CH"CK LEVER
VA LVE
VALVE NUT