Error Codes - Canon EOS 60D Instruction Manual

Error Codes

Countermeasures
No.
Communications between the camera and lens is faulty. Clean the
lens contacts.
01
 Clean the electrical contacts on the camera and lens and use a
Canon lens (p.13, 16).
Card cannot be accessed. Reinsert/change card or format card
with camera.
02
 Remove and insert the card again, replace the card, or format the
card (p.32, 48).
Cannot save images because card is full. Replace card.
04
 Replace the card, erase unnecessary images, or format the card
(p.32, 48, 215).
The built-in flash could not be raised. Turn the camera off and on
again.
05
 Operate the power switch (p.28).
Sensor cleaning is not possible. Turn the camera off and on again.
06
 Operate the power switch (p.28).
Shooting is not possible due to an error. Turn the camera off and
10, 20,
on again or re-install the battery.
30, 40,
50, 60,
 Operate the power switch, remove and install the battery pack
70, 80
again, or use a Canon lens (p.26, 28).
* If the error still persists, write down the error No. and contact your nearest
Canon Service Center.
If there is a problem with the camera, an
Error No.
error message will appear. Follow the on-
screen instructions.
Error Message & Solution
291