Sound Board - Toshiba QOSMIO G20 Maintenance Manual

4.15 Sound board

4.15 Sound board
Removing the sound board
The following describes the procedure for removing the sound board (See Figure 4-25).
1. Disconnect the Sound harness from the connector CN9510 on the SD board.
2. Disconnect the Power SW harness from the connector CN9521 on the SD board.
3. Turning up the insulator, remove the following screws securing the SD board and
remove the SD board from the cover assembly.
M2.5x3.0S
Power SW harness
4-42 [CONFIDENTIAL]
FLAT BIND screw
M2.5x3.0S FLAT BIND
Figure 4-25 Removing the sound board
x3
Sound board
CN9521
QOSMIO G20 Maintenance Manual (960-511)
4 Replacement Procedures
Sound harness
CN9510
M2.5x3.0S FLAT BIND