Iap Sensor (#1) Removal And Installation; Iap / Tp / Iat Sensor Inspection; Iap / Tp / Iat Sensor Removal And Installation; Ect Sensor Removal And Installation - Suzuki GSF650A Service Manual

1C-2 Engine Electrical Devices:

IAP Sensor (#1) Removal and Installation

Removal
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Disconnect the IAP sensor (#1) coupler (1) and
vacuum hose (2).
3) Remove the IAP sensor (#1) (3).
1
Installation
Install the IAP sensor (#1) in the reverse order of
removal.

IAP / TP / IAT Sensor Inspection

Refer to "DTC "C17" (P1750-H/L): IAP Sensor (#2)
Circuit Malfunction in Section 1A (Page 1A-54)", "DTC
"C14" (P0120-H/L): TP Sensor Circuit Malfunction in
Section 1A (Page 1A-39)" and "DTC "C21" (P0110-H/L):
IAT Sensor Circuit Malfunction in Section 1A (Page 1A-
62)".
NOTE
IAP sensor (#2)/TP sensor/IAT sensor are
combined into one.

IAP / TP / IAT Sensor Removal and Installation

Refer to "Throttle Body Disassembly and Assembly in
Section 1D (Page 1D-11)".
CAUTION
!
• Never remove the IAP/TP/IAT sensor from
the throttle body.
• The IAP/TP/IAT sensor, STVA and throttle
body are available only as an assembly.
B817H21306005
3
2
I717H1130003-01
B817H21306006
B817H21306007

ECT Sensor Removal and Installation

Removal
1) Drain engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page 0B-14)".
2) Disconnect the coupler (1) and remove the ECT
sensor (2).
CAUTION
!
Take special care when handling the ECT
sensor. It may cause damage if it gets a sharp
impact.
2
Installation
Install the ECT sensor in the reverse order of removal.
Pay attention to the following points:
• Tighten the ECT sensor to the specified torque.
CAUTION
!
Use the new gasket washer (1) to prevent
engine coolant leakage.
Tightening torque
ECT sensor (a): 18 N·m (1.8 kgf-m, 13.0 lbf-ft)
1
• Pour engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page 0B-14)".
B817H21306008
1
I717H1130004-01
(a)
I717H1130005-01