03 Setting Up Automation Or Machine Torch - Thermal Dynamics cutmaster A60 Operating Manual

3T.03 Setting Up Automation or
Machine Torch
An adapter is required to be installed in the
power supply if converting a hand torch system
to operate a machine or automation torch.
Disconnect primary power at the source before
disassembling the torch or torch leads.
The Automation and Machine torch include a
positioning tube with rack and pinch block assem-
bly.
1. Mount the torch assembly on the cutting
table.
2. To obtain a clean vertical cut, use a square
to align the torch perpendicular to the sur-
face of the workpiece.
Workpiece
Automated and Machine Torch Set - Up
3. The proper torch parts (shield cup, tip, start
cartridge, and electrode) must be installed
for the type of operation. Refer to Section
"4T.03 Machine and Hand Torch Parts
Selection" for details.
Manual 0-4981
NOTE
WARNING
Pinch Block
Assembly
Square
A-02585
3T-3
cutmaster a60
INSTALLATION