Adjustment Of The Vcr Electrical Circuitry - Sharp 13VT-R100 Service Manual

13VT-R100/R150
13VT-CR10

ADJUSTMENT OF THE VCR ELECTRICAL CIRCUITRY

Notes:
» Before the adjustment:
Electrical adjustments described here are often required after replacement of electronic components and mechanical
parts such as video heads.
Check that the mechanism and all electric components are in good working condition prior to the adjustments,
otherwise adjustments can not be completed.
» Instruments required:
Dual-trace oscilloscope
Blank video cassette tape
Screwdriver for adjustment
Color bar generator
DC voltmeter
Alignment tape (VROATSV), (VRONBZGS)
» Adjustment of the VCR should be done in the TV/VCR combinated style. But there is a function to cut off the high
voltage of TV. Namely, you can check only VCR part by taking the wire lead RC off . Therefore you can use function
on the occasion of checking and adjusting VCR part.
SERVO CIRCUIT ADJUSTMENT
ADJUSTMENT OF HEAD SWITCHING
POINT
Measuring Dual-trace oscilloscope
instrument
Mode Playback
Cassette Alignment tape (VROATSV)
Test point TP2201 (Video Out) to CH1
TP3302 (Trigger) to CH2
Control Remote Control
Specification 5.5 ± 0.5H (lines)
1. Play the alignment tape.(VROATSV.)
2. Press the CH " (TR
remote control at the same time to turn the set into the
adjustment mode for head switching point and to set
the tracking to center. (See Notes below) "T" is
displayed on the TV screen.
3. Press the PLAY button of remote control to make the
adjustment of head switching point, then the leading
edge of the head switching pulse is automatically set
5.5H (lines) ahead of the vertical sync as shown Figure
2-1 and the adjustment data is memorized in the E
ROM IC.
4. Then press the stop button to stop the tape.
— ) button and the "0" button of
CH-1
VIDEO OUT
CH-2
HEAD
SWITCHING
PULSE
Notes:
1 To make this adjustment, disable the AUTO TRACKING
function.
» The AUTO TRACKING function is disable in the
following cases. (In the playback mode only.)
a When the CH " (TR
of the remote control are pressed at the same time.
b When the AC cord is plugged in with making TP7701
and TP7702 short circuited, after the cassette
housing control ass'y is removed.
(Mechanism operating mode)
» The AUTO TRACKING function becomes available in
the following cases.
a When the CH ' (TR
— ) button of the remote control are pressed at the
same time.
2 P-
b When the AC cord is plugged in with the cassette
housing control ass'y put back.
2 Pressing both the CH " (TR
transmits the test code. When the unit receives this
test code in the playback mode, the unit is turned into
the adjustment mode for the head switching point and
"T" is displayed at the position of CH number on the
screen. This function is available to the remote control
RRMCG1330PESA and RRMCG1330PESB.
40
CH-1:1V/div 50µsec/div
CH-2:2V/div 50µsec/div
5.5±0.5H(Iines)
Figure 2-1.
— ) button and the "0" button
± ) button and the CH" (TR
— ) and the "0" button
V-sync.