Installation Confi Guration 4; Telestart Vw Mqb (Lin); Telestart Vw Pq (W-Bus) - dfreeeze parking heater remote control Installation Manual

Installation confi guration 4 & 5
The installation confi gurations 4 & 5 describe the
connection of the dfreeeze
parking heater (installed ex works or retrofi tted as an
original accessory).

Installation confi guration 4:

Vehicles based on MQB (e.g. VW Golf VII,
EN
Skoda Oktavia III)
Switching output - Pin 3*
Switching input - Pin 4*
Installation confi guration 5:
Vehicles based on the PQ-platform (e.g. VW Golf VI,
VW Touran)
Switching output - Pin 3*
Switching input - Pin 4*
38
® receiver to an original VW
Telestart VW MQB
12V continuous signal
12V continuous signal
(for response)
Telestart VW PQ
12V switching impulse
12V continuous signal
(for response)
*The information refers to the signals on the dfreeeze
receiver (plug X3).
If no feedback signal to pin 4 on plug X3 is
present, the proper function of the dfreeeze
cannot be guaranteed.
Preparation of the adapter cable
●
To connect an original VW parking heater, the
plugs X1 and X2 must be replaced with the
blue VW plugs.
●
Connect the plugs X1 and X3 as shown in the
cable diagram on the right.
Note the information on page 32 when
preparing the cable.
Connecting the dfreeeze
●
Connect the plug connector with the respective
devices as shown in the system diagram to the
right.
®
®
®
receiver