Receiver And Remote Control Programming - Craftsman 139.18076 Owner's Manual

Receiver and Remote Control Programming

To comply with FCC/IC rules, adjustment or modifications of this receiver
and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
SECURITY
Your garage door opener receiver and remote control
have been pre-set at the factory. The door will open
when you press the LARGE remote control push
button. The code between the remote control and the
receiver changes with each use, randomly accessing
over 100 billion new codes.
The 3-function remote control can also activate
additional SECURITY
light controls.
Your SECURITY opener will operate with:
• several SECURITY remote controls (with blue
push buttons) utilizing up to 8 functions.
• one SECURITY Keyless Entry System
(Model 18795).
The opener must learn the code of any new remote.
Follow the instructions below to program your opener
to match any additional remotes you may purchase.
See Accessories on page 38.
To Add A Remote Control
If you have a Premium Control Console:
1. With the door closed, press and hold a button on
the remote to be programmed. See Figure 1.
2. Press and hold the Light button on the door
control.
3. Press and hold the door control push button.
Light bulb on the opener will flash once when it
has learned the code.
4. Release all buttons.
Test by pressing the remote push button.
If you do not have a Premium Control Console:
1. Press and hold a button on the remote to be
programmed. See Figure 1.
2. Press and release the SRT (Smart
Receiver/Transmitter) button on the opener,
Figure 2. Light bulbs on the opener will flash
once when it has learned the code.
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the SRT button on the opener for
6 seconds. The indicator light will turn on . Release
the SRT button when it turns off. All codes are now
erased from the opener. Then follow the the steps
above to re-program each remote control.
garage door openers and/or
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause serious
injury or death. Do not allow children to operate
the door push button(s) or remote control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Figure 1
Select a remote control push
button to operate opener
SECURITY
3-FUNCTION
REMOTE CONTROL
Figure 2
To Control the Opener Light (Premium Consoles)
With SECURITY remote controls, a push button can
be programmed to operate the opener light without
opening the door.
1. With the door closed, press and hold the remote
button that you want to control the light.
2. Press and hold the Light button on the door
control.
3. Press and hold the Lock button on the door control.
4. After the opener light flashes, release all buttons.
Test by pressing the remote push button. The opener
light should turn on or off but the door should not move.
33
WARNING
SECURITY
COMPACT 3-FUNCTION
REMOTE CONTROL
SECURITY
Garage Door Opener
(With "SRT" Button)
1
2
9 9
1
7
3
5
KG
"SRT" Indicator
PANEL
Button Light
3
1
7
3
5
KG
BACK