This dishwasher must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive an Installation Instructions sheet with your dishwasher, you can receive one by visiting our website at ge.com. I Connect to a grounded metal, permanent wiring I Do not attempt to repair or replace any part system;...
Page 3
® rinse agents have been of small fingers being pinched in door. approved for use in all GE dishwashers. I Do not discard a dishwasher without first removing I Locate sharp items so that they are not likely the door of the washing compartment.
About the dishwasher control panel. You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model. Please match the control panel for your unit to a similar control panel below. HOT WASH OPTION HEAVY WASH NORMAL WASH...
Control Settings Cycles POTS & PANS/ For heavily soiled dishes or cookware with dried-on or baked-on soils. Everyday dishes may be included. HEAVY WASH This cycle will not remove burned-on foods. (on some models) NORMAL/ For loads of everyday dishes, glasses and cookware with medium soils. NOTE: Many dishes have lighter NORMAL WASH soil than normal.
Page 6
About the dishwasher control panel. Control Settings Start (Models without a Dial) Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 60 seconds later the wash action begins. NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON and display the last settings you selected.
GSD1000 Hot Start Option GSD1100 Heavy Wash Normal Wash Rinse Only Drying/Plate Warmer HDA1000 Hot PreWash Option HDA1200 Normal Wash ADW1000 Drying/Plate Warmer Rinse Only GSD1200 Hot Start Option Heavy Wash Normal Wash Short Wash Rinse Only Drying/Plate Warmer GSD2000...
About the dial cycles. Rinse Only HOT START OPTION START For rinsing partial loads that will be washed later. Do not use detergent. START DELAY (HRS) Make sure HEATED DRY is not selected. Slowly turn the Dial to RINSE ONLY. SHORT WASH Be sure the door is unlatched.
Flashing display lights (model GSD3900 only). ge.com Lights What It Means What To Do This is normal. Allow the dishwasher to drain and reset before you start a new wash cycle. The START/RESET pad has been pressed. START START RESET Control Error Press the START/RESET pad to turn off the beeper.
Otherwise, the detergent cup will not close and latch Dishwashing Detergents have been approved for use properly. Add detergent then close the main cup. in all GE dishwashers. Keep your detergent fresh and Open cup dry. Don’t put powder detergent into the dispenser until you’re ready to wash dishes.
Loading the dishwasher racks. ge.com For best dishwashing results, follow these loading guidelines. Features and appearance of racks and silverware baskets may vary from your model. Upper Rack Secure larger dishwasher-safe plastics over The upper rack is for glasses, cups and two fingers when possible.
Stainless Steel Panels The stainless steel panels can be cleaned You can order Stainless Steel Magic with Stainless Steel Magic or a similar #WX10X15 through GE Parts by calling product using a clean, soft cloth. 800.626.2002. About optional accessories. You can change the door and lower access...
Stained tub interior Some tomato-based • Use of the RINSE ONLY cycle after adding the dish to the load foods can cause reddish can decrease the level of staining. GE recommends Cascade ® stains Plastic Booster to help remove these types of stains.
Before you call for service… Problem Possible Causes What To Do Dishes don’t dry Low inlet water • Make sure inlet water temperature is at least 120°F. temperature • Select HEATED DRY. • Use HOT START and ADDED HEAT options. •...
This warranty is extended to the original purchaser and any succeeding owner for products purchased for home use within the USA. If the product is located in an area where service by a GE Authorized Servicer is not available, you may be responsible for a trip charge or you may be required to bring the product to an Authorized GE Service location.
Contact Us ge.com If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: General Manager, Customer Relations...