Speed Control Cable - Pioneer Brite Striper 2000 Instruction Manual & Parts List

STEP 4.

SPEED CONTROL CABLE

PARTS REQUIRED:
Throttle Control Cable is already attached and pre-set
at Speed Control Lever.
2 - 3/4" x 1/4" - 7/16" Hex Head Bolts
2 - 7/16" Hex Head Self Locking Nuts
TOOLS REQUIRED:
7/16" Socket
7/16" Open End Wrench
Step 1: Line up holes in speed cable bracket with the holes on
Step 2: Insert 7/16" hex head bolts through holes and attach
Step 3: Remove cotter pin from clevis pin and set aside.
Step 4: Remove clevis pin and set aside.
Step 5: Line up holes on clevis with linkage on speed
Step 6: Insert clevis pin through aligned holes.
Step 7: Insert cotter pin into bottom of clevis pin and bend open
front side of engine base.
7/16" hex head self-locking nuts then tighten.
control valve.
the tails of cotter pin to secure.
2
MODEL 2000