Omron FQ2-S/CH Series User Manual page 64

Select the IP address to be used by PC Tool
The computer IP address, subnet address, and default gateway that are used by the PC Tool are displayed. If
multiple IP addresses (network cards) exist in the computer, the IP address to be used for the PC Tool can be
selected.
(Setup Mode or Run Mode) − [TF settings] − [Ethernet] − [IP address]
1
A list of the computer IP addresses that can be used by
the PC Tool appears. Touch the list to select an IP ad-
dress.
2
The Sensor List appears.
The connected sensor is temporarily disconnected. To re-
fresh the list, touch [Update list] of any sensor.
3
Select the sensor that you want to connect and touch
[OK]. (The sensor is reconnected.)
Note
• If you want to change the IP address, change the network settings of the computer and then select the IP address
using the above procedure.
• If the list does not appear, check if the LAN is correctly connected.
62
Setting Up Ethernet FQ2-S/CH User's Manual