Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for First Data FD100Ti
Summary of Contents for First Data FD100Ti
- Page 1 First Data™ FD100 Terminal quick Set-Up Guide...
- Page 2 Thanks for choosing a First Data™ Terminal. First Data Terminals are some of the fastest, most secure point-of-sale terminals available. Installation is quick and easy. Simply follow the instructions and begin accepting card transactions today. What’s in the box? • First Data™ FD100 Terminal •...
- Page 3 What else will you need? If connecting through Cable: • Router • Modem • Ethernet Cable • Coaxial Cable If connecting through DSL: • Router • Modem • Ethernet Cable (2) If connecting through Dial-up: • Splitter (optional) Note: To prevent damage to the FD Terminals and connected devices, we strongly recommend using a surge protector or UPS (Uninterruptible Power Supply) with a battery backup and phone/fax protection.
- Page 4 Getting to know the FD100 ETHERNET COM1 PHONE Port connections The pictures show an FD100 terminal. The ports on the back of the FD100 terminal enable you to add peripherals such as PIN pads, check readers and contactless readers. Phone (blue) ➔...
- Page 5 Note: If you open the cover on the bottom of the terminal you will find two additional ports. The left is a USB port and the other is a mini USB port. Caution: The USB port cover should be kept closed during normal operation.The USB port cover shall not be removable from other parts of the FIRE ENCLOSURE by the OPERATOR AC INPUT...
- Page 6 Let’s get started... Typical set-up time: 10-15 minutes Where to put the FD Terminal Place the terminal on a desk or tabletop. Avoid areas with direct sunlight, objects that radiate heat, excessive dust and other electrical devices that can cause excessive voltage. Loading the paper Pop the printer cover’s latch to open the cover;...
- Page 7 RoUTER moDEm Ethernet Cable oUTLET Phone Cord...
- Page 8 Cable RoUTER moDEm CABLE Ethernet Cable oUTLET Coaxial Cable...
- Page 9 Dial-up (dedicated line) Option 1 PhoNE jACk Phone Cord Dial-up Option 2 PhoNE jACk SPLITTER Phone Cord PhoNE/FAX...
- Page 10 Plug in the power Before using the power supply, please connect all peripherals to the terminal. Not doing so may result in damage to the unit or connected devices. Connect the power cord to the power supply via the three-prong end and receiver.
- Page 11 Using the card reader With the idle message displayed, select the desired transaction type. Insert the card into the card reader slot, with the magnetic stripe lying in the slot and facing the terminal. Slide the card in either direction through the slot without stopping. If the card swipe fails, check the position of the magnetic stripe and slide the card again.
- Page 12 NoTICE: This equipment meets the be required to correct the interference at applicable Industry Canada Terminal his own expense. Equipment Technical Specifications. This is confirmed by the registration number. © 2010 First Data Corporation. All Rights Reserved MIS-FDSER-SUGDE...
Need help?
Do you have a question about the FD100Ti and is the answer not in the manual?
Questions and answers