References - Aeroflex GR-UT699 User Manual

One Serial UART interface (RS232)
•
Ethernet
•
JTAG - DSU
•
Two CAN bus interfaces
•
Four Spacewire interfaces
•
Serial DSU UART (Mini-AB USB connector)
•
16 pins General Purpose I/O Port
•
Push Buttons for RESET and BREAK
•
LED indicators
•
To enable convenient connection to the interfaces, the connector types and pin-outs are
compatible with the standard connector types for these types of interfaces.
Additionally the board is equipped with a 32 bit Master/target PCI interface via standard
Compact PCI Connector interface on the back edge of the PCB.
The PCB contains the following main items as detailed in section 2 of this document:
UT699RH ASIC
•
Memory
•
•
•
•
•
•
Interfaces
•
•
•
•
•
•
•
•
Power, Reset, Clock and Auxiliary circuits
•

1.2 References

RD-1 GR-UT699_schematic.pdf, Schematic
RD-2 GR-UT699_assy_drawing.pdf, Assembly Drawing
RD-3 UT699RH Datasheet
RD-4 GR-MEZZ Technical
© Aeroflex Gaisler AB
SRAM 80 Mbit
SDRAM SODIMM socket
FLASH 128Mbit
EEPROM DIL32 socket
additional memory via memory expansion connector
two CAN interfaces
four Spacewire LVDS electrical interfaces
one serial UART (RS232) interface
10/100MBit Ethernet PHY
DSU - Serial (over USB Converter) interface
DSU - JTAG (over JTAG connector) interface
GPIO (16 signals) general purpose input/output port
Note, Technical Note about Mezzanine connectors
8 GR-UT699 Development Board
(1 banks x 2Mword x 40 bit, typ. 10ns)
(optional second bank is not fitted as standard)
(up to 64Mword x 40 bit with 512Mbyte module)
(4M x 32 bit, typ. 90ns)
(1 bank x 1Mbit, organised x8 bit wide)
User Manual
March 2013, Rev. 0.6