Advertisement
DP 6000 DIGITAL PAGING SYSTEM
February 1997
2. INTRODUCTION
For the operation of the transceiver refer to the 'User Guide'
supplied with each transceiver. The following gives an overview
of a transceiver. The version illustrated is the LBB 6066/..
Personal security transceiver.
The paging transceiver has four main functions:
1. To alert the transceiver carrier when called with one of 14
different bleep patterns.
2. To display 5-digit numeric and 24 character alphanumeric
messages (display versions only).
3. To provide two-way verbal communication between cen-
tral control and other DP6000 transceiver carriers.
4. To provide personal security (LBB 6065/.. and LBB 6066/..
versions only)
KEY TO SYMBOLS (Fig. 1)
1. Antenna
2. Tear-out alarm. (includes chain attachment, /06,/07 and /08
only)
3. 5-digit numeric display
4. Status indication:
Red - Transmitting
Green - Receiving
5. Numeric message memory <Recall> and <Reset> button
6. Chain securing attachment
7. Connection cover for external unit (available with versions
LBB 6063/09, LBB 6064/09, LBB 6065/08 & /09 and
LBB 6066/08 & /09 only)
8. Scroll buttons (up/down to scroll menu options and
browse stored alphanumeric messages)
9
Menu button (activates transceiver options)
10. Label placement
11. Storage rack securing attachment
12. Charging contacts (for use in storage rack)
13. Battery compartment ( 3 x LR1)
14. Dial keypad (LBB 6064/xx & LBB 6066/xx only for direct
selection of call numbers)
15. <Light> button (press to switch on display back-light in low
light conditions). This button can be programmed to trans-
mit the second pilot tone (Opcode programming).
16. 'Enter' button (to select options from menu)
17. Alphanumeric LC display (to display incoming messages or
set-up menu)
18. <Press-to-talk> switch
19. <Alarm> key (LBB 6065 & LBB 6066 only)
Rear of transceiver (Fig.2)
18. <Press-to-talk> switch
20. Storage rack securing attachment
21. Microphone
22. Loudspeaker
23. Panel mounting screws (4 off)
INSTALLATION INSTRUCTION 83
DISPLAY SYMBOLS (display versions only)
When activated a display bar is displayed under the relevant
symbol.
(A)
Low battery voltage indicator. (If programmed
accompanied by a bleep until reset)
(B)
Out of Range indicator (if active in the system). No
calls can be received and a bleep signal emitted until
reset. After 32 minutes (out-of range status) the
transceiver switches off automatically
(C)
Message locked indication (applicable also for pre-
programmed short calls)
(D)
Bleep-on indication
(E)
Bleep volume level indication (programmable loud or
soft)
(F)
Transceiver in programming mode.
(G)
Pilot tone indication (I or II)
(H)
Alarm indication (indicates if one or more of the
programmable alarms are enabled)
(I)
Memory index number of alpha message displayed in
Fig.1 Transceiver LBB 6066/..
2
1
19
18
17
16
15
14
12
A
B
D
C
Page 2/29
3
4
5
6
7
8
9
10
11
12
13
P
E
F
G
H
7
I
Advertisement
