Operating Instructions; Cycle Selection - Electrolux Electric Dryer Owner's Manual

Cycle Selection

Turn cycle selector clockwise to desired cycle and setting.
For best results
Follow the fabric care label
instructions on items to be
dried.
Each cycle ends with a cool down period. The heat
automatically turns off and the load continues to tumble
during the cool down period. This reduces wrinkling and
makes items easier to handle during unloading.
Drying time varies depending on size and dampness of load
and fabric type. Room temperature and humidity, type of
installation and electrical voltage or gas pressure can also
affect drying time.
AUTO FABRIC / AUTO SYNTHETICS / AUTO WHITES
Drying time is determined automatically at the temperature
selection of your choice.
• Medium heat is suggested for permanent press items.
• Initially set cycle selector on
• For items requiring more drying time, set cycle selector
on more dry.
• For items requiring less drying time, set cycle selector on
less dry.
• A signal will sound toward the end of the cool down
period when the end of cycle chime is turned on.

OPERATING INSTRUCTIONS

PUSH TO START
PUSH TO START
normal dry (on select models).
Auto Fabric Care
AUTO COTTON / AUTO COLORS (on select models)
This cycle is best for cotton items. Drying time is determined
automatically at the temperature selection of your choice.
• High heat is suggested for cotton items.
• Medium heat is suggested for permanent press items.
• Low heat is suggested for knit and delicate items.
If the dried load cannot be removed promptly, the cycle
selector will advance to the Wrinkle Free/Press Saver (on
select models) setting where unheated tumbling continues
for approximately 30 minutes to help reduce wrinkling.
Unless the Cycle Signal has been turned off, it will sound
briefl y every 5 minutes as a reminder to remove the load.
TIMED DRY
This cycle provides up to 70 minutes (or up to 100, on
select models) of drying time at the temperature selection
of your choice.
When drying permanent press items, turn the cycle selector
to the Perm Press (on select models) setting (30 - 40
minutes). This is the average time needed to dry most loads
of permanent press items.
Temperature Selection
Always follow directions on fabric care labels.
- FIRE HAZARD - To avoid fi re hazard, do not
use heat to dry items containing feathers or down, foam rub-
ber, plastics, or similarly textured, rubber-like materials. Use
the Timed Dry cycle and the Air Fluff/No Heat setting.
The high heat, medium heat, and low heat temperature
settings may be used with any cycle setting. The air fl uff-no
heat setting can be used only in the Timed Dry cycle. Air fl uff-
no heat setting tumbles the load without heat. Use air fl uff to
freshen clothing, pillows or blankets, or to dust draperies.
5
Perm Press