Troubleshooting; Reset Button - Reiner jetStamp 790 Operating Instructions Manual

Display Cause
IMPRINT Time allowed by 'Block Imprint'
BLOCKED has expired, disappears trigger
has been pressed
WRONG Wrong base station,
STATION jetStamp needs an intelligent
base station
Error 04 Memory error
Error 09 • Sensor or motor defective
• Print carriage blockade
i • If the Reset button is pressed, various settings are lost,
e.g .date and time and the battery charge indication.
jetStamp must then be placed in the charging station for
Note
about 3 hours to synchronise the state-of-charge indicator.
• If the battery has been discharged too far, the charging
process may cause confused signs to appear in the display.
Pressing the Reset button will cure this condition.
• To operate the Reset button, insert a straightend paper clip
or similar object through the opening in the rear face
of the stamp

Troubleshooting

Reset button

Recommendation
Press [ QUIT ] :
jetStamp is then ready
for use again
Press [ QUIT ] :
Error message
disappears and previous
display reappears
Press [ QUIT ]
Press [ QUIT ]
and start stamping again
25