Table of Contents
Advertisement
USB Ports
Your Designer SE has two USB ports – one to
connect the sewing machine to your computer,
and one to connect either your USB Embroidery
Stick, optional CD-drive, optional fl oppy disk
drive or optional mouse.
: Contact your dealer for USB devices for your
NOTE
Designer SE.
Connect to and Remove from USB Port
Insert the USB Embroidery Stick or other devices
in the upper port, and the USB cable to your PC
in the lower port. The USB plugs can only be
inserted one way – do not force them into the
ports!
The USB cable packed with your Designer SE
plugs in to the lower port. No other cable should
be used in this port.
To remove, carefully pull the USB Embroidery
Stick or the plug of the USB cable out straight.
USB Embroidery Stick
Delivered with your Designer SE is a USB
Embroidery Stick with 32 MB memory which
corresponds to 300-6000 designs depending on
the stitch count. Use the stick to store designs and
other fi les, or to move fi les between the computer
and sewing machine. Upon delivery, four designs
are stored on the USB Embroidery Stick.
Switch write protection on and off with the switch
on the underside of the USB Embroidery Stick.
: The USB Embroidery Stick must be removed
NOTE
from your Designer SE before switching write
protection on and off.
Only original Husqvarna Viking USB Embroidery
Sticks will be supported.
Using the USB Embroidery Stick
A light at the end of the stick indicates that the
USB Embroidery Stick is plugged in correctly.
When loading from or saving to the USB
Embroidery Stick, the light fl ashes and an
hourglass appears on screen.
Do not remove the USB Embroidery Stick
while the light is fl ashing or when the
hourglass is shown, as this can damage the fi les
on your USB Embroidery Stick.
Set it Up
Designer SE to Computer Connection
To be able to connect your Designer SE with
your computer, install 3D Organizer with
Designer SE communication on your computer.
Insert the 3D Embroidery Software CD delivered
with your Designer SE into your computer CD
drive and follow the instructions.
: Your computer must be running Windows XP.
NOTE
Right position – write protected
Left position – not write protected
1-21
Advertisement
Table of Contents
Need help?
Do you have a question about the Designer SE and is the answer not in the manual?
Questions and answers
Husqvarna Viking Designer SE
@Louise Girard
How do I know what embroidery unit to buy?
how do i outline letters
I cannot get the foot of the sewing machine to go down on top of the throat plate. It will not go up or down.
To fix the foot on the Husqvarna Viking Designer SE sewing machine that is stuck and won't move up or down, follow these steps:
1. Check the Free Motion Setting: If Free Motion mode is activated, the foot may behave differently. In Free Motion, the foot raises and lowers with each stitch below 200 stitches per minute and floats over the fabric above that speed. Turn off Free Motion mode if it's not needed.
2. Sensor Q-Foot Mode: If the machine is set for the Sensor Q-foot, it limits stitch width and may affect foot movement. Turn off this setting if you are not using the Sensor Q-foot.
3. Power Cycle the Machine: Turn off the machine using the ON/OFF switch, unplug it from the wall and the machine, then plug it back in and turn it on again. This may reset the foot positioning mechanism.
4. Check for Obstructions: Ensure there is no fabric, thread, or debris blocking the foot mechanism.
If the foot still does not move after these steps, there may be an internal mechanical or electronic issue requiring service.
This answer is automatically generated
@Mr. Anderson thank you for your help. Much appreciaated
I have a Husqvarna Designer SE. I cannot get the machine to lower the walking foot to machine quilt. Can you help me?