Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for SHOWTEC Light Desk Pro 136
Summary of Contents for SHOWTEC Light Desk Pro 136
- Page 1 Light Desk Pro 136 User Instructions 1 2 3 4 5 6 1 2 3 4 5 6 AUTO Page St ep Tap Sync Stand By Fade Speed Audio Ful l On SCENE CHASE 0.05s SPEED AUDIO SCENE CHASE FIXTURE...
-
Page 2: Table Of Contents
PARs jointly and effectively according to different requirements towards scenic lighting effect. 2 Safety Rules In order to use the Light Desk Pro 136 more availably and effectively, please take good care of this unit. The following rules give important information regarding safety during use and maintenance. -
Page 3: Notice Information
• MIDI control over scenes, chases and blackout • Audio input and built-in microphone for music sync. function 4.2 Specifications • Model Light Desk Pro 136 • Power Input DC 9~15V, 600 mA min. • LCD 2×16 characters • Audio Trigger Built-in microphone or line in •... - Page 4 To activate the “STEP” function or switch between the Mix mode and the Sequence mode. • TAP SYNC button: Repeatedly tap this button to establish different chase rate. • AUDIO button: Used to activate audio sync of chase rate or set a scene at audio effect. •...
-
Page 5: Rear View
To adjust for best audio effect. • MASTER slider: Used to proportionally and totally change the overall console output. 5.2 Rear view • POWER ON / OFF : Used to switch on / off the power. • DC INPUT : DC 9 ~15V , 500mA min. -
Page 6: Program / Record A Fixture Chase
setting. (4) select another series of fixtures, repeat step (3). Press RECORD button to record this scene, all LEDs will flash suddenly. User can then set and record another Scene as desire. Note: In Record mode, user can delete a Fixture Scene. Select and press a recorded Scene button in the Record mode, its LED will blink quickly. -
Page 7: Delete A Fixture Chase (Operation Upon Pars)
Press STEP button, the chase will step forward while the program running. • AUDIO Press AUDIO button while chase running, the AUDIO LED will light up, that means you have entered the “AUDIO” mode. FADE TIME will be useless, and the “TAP SYNC” LED will blink according to the audio effect. -
Page 8: Select / Deselect A Par Scene
6.6.1 select / deselect a PAR Scene (1) Press the PAGE button, its LED will be lit, you can select t scene page by UP/DOWN button. PAGE:×× will be shown on the top left corner of the LCD-display. (2) If the Scene LED is “on”, that means the scene was programmed. While “off ” means unprogramed. Press the programmed Scene button to reactivate the PAR Scene. -
Page 9: Read From The Cf Card
• Enter the setting mode, choose 1. CF CARD and press RECORD button , LCD will show you: Then please press “UP/DOWN” to choose 2 .STORE TO CF , press “RECORD” again for further operation. • Select relevant location (1-99) by UP/DOWN buttons to save the data, and then press the RECORD button for recording , press ESC button to exit. -
Page 10: Notice For Cf Card
• Turn off the power when connect or disconnect CF card with the unit. • CF card (32M) can be used only for Light Desk Pro 136, otherwise the data would probably be missing. • Outputting of DMX would be stopped during the reading or storing to CF card. And so does to “ASSIGN CH.”... - Page 11 Memory will be cleared within 5 seconds.
Need help?
Do you have a question about the Light Desk Pro 136 and is the answer not in the manual?
Questions and answers