JVC VR-N900U Instructions Manual page 61

4
Select [Remove Flash Memory].
• You will be asked to confirm that you want to remove the
flash memory. Click the [OK] button.
• A message informing you that the flash memory has been
removed will be displayed. Click the [OK] button.
5
Remove the flash memory from the SERIAL
port on the front or rear panel.
Note
• Settings data is saved to the VR-N900 folder in the flash
memory (USB memory).
• If you want to save additional settings data after selecting
[Remove Flash Memory], remove the flash memory from
the serial port, then insert it again. When the flash
memory is inserted, it will be automatically detected.
●[Load Setting Data]
This lets you read settings data from the flash memory.
1
Insert the flash memory into the SERIAL port
on the front or rear panel.
2
Select [Load Setting Data].
• If data has been saved to the flash memory, a list of the
data that has been saved will be displayed in the settings
data list.
• A message informing you that the flash memory cannot be
detected may be displayed. If this happens, wait
approximately 30 seconds, then select [Load Setting Data]
again.
• Settings data that has been saved on this VR-N900U will
be preceded by My Machine. If the data was saved on
another VR-N900U, it will be preceded by Other Machine.
This will be followed in parenthesis by the MAC address of
the VR-N900U at the time the data was saved. This in turn
will be followed by the date/time when the data was saved
in the form [yyyy – mm – dd – sec – Setting].
• If several data are displayed, highlight the data in the list
that you want to read.
[Setting Data List] window
3
Select [Load], then click the [ZOOM IN/ENTER]
button on the front panel.
The highlighted data will be read.
4
You will be asked to confirm that you want to
read the settings data. Click the [OK] button.
• The settings data will be read.
• When reading is finished, a message informing you that
the data has been read will be displayed. Click the [OK]
button again.
5
Click the [Close] button. You will be returned
to the [Flash Memory Utility] window.
6
Select [Remove Flash Memory].
• You will be asked to confirm that you want to remove the
flash memory. Click the [OK] button.
• A message informing you that the flash memory has been
removed will be displayed. Click the [OK] button.
7
Remove the flash memory from the SERIAL
port on the front or rear panel.
Note
• Items specified in [Screen Setup], [Camera Record
Setting] and [Image Server Setting] in the Main Menu will
not be read.
• If you want to read additional settings data after selecting
Remove flash memory, remove the flash memory from the
serial port, then insert it again. When the flash memory is
inserted, it will be automatically detected.
61