Programming With Npst-Gr Software; System Configuration - NAiS FP1 Hardware Manual

4-3. Programming with NPST-GR Software

NPST-GR Software Ver. 3.1 offers program entry, editing, and monitoring of FP series programmable controllers.
With this software, you can concentrate on the control pattern rather than wasting time learning how to enter the
program.

1. System Configuration

Personal Computer (IBM PC-AT
or 100% compatible) 550 KB
of free main memory plus
800 KB of free EMS 2 MB
or more hard disk space
Connection between a Programmable Controller and a Computer
• An FP1 Peripheral Cable, an RS422/232C Adapter, and an RS232C cable are required to connect a personal
computer to an FP1.
Setting of FP1
• Set the baud rate selector of the FP1 to 19200 or 9600.
Note:
• If the microprocessor of your computer works at 8 M Hz or 16 M Hz, set the baud rate selector of the FP1
to 9600 bps.
Personal Computer Setting
• Set your personal computer's RS232C parameter to asynchronous. Refer to the manuals that came with your
computer.
Baud rate selector
19200 bps
9600 bps
RS422/232C Adapter
(AFP8550)
RS232C cable
NPST-GR
Software Ver. 3.1

4-3. Programming with NPST-GR Software

FP1 Programmable Controller
BATTERY
+
24V DC
F.G.
RUN
PROG.
ERR.
ALRAM
min. max.
V0
-
24V DC
+
RS422/232C ADAPTER
MATUSITA ELECTRIC WORKS. LTD
MADE IN JAPAN
POWER
TXD(-)
RXD(-)
- COM COM COM COM COM COM COM COM
0 1 2 3 4 5 6 7
RUN
REMOTE
PROG.
min. max.
V1
COM 8 A C E COM 0 2 4 6
(+) - 9 B D F (+) - 1 3 5 7
FP1 Peripheral Cable
(AFP15205: 50 cm)
67