Accessories; Terminal Block; Remote Aerial; Electric Key Switch - Controll-A-Door S series Instruction Manual

Accessories

Step 17.1 - Terminal Block
A variety of wired accessory items can be connected to the
terminal block such as Safety Infra-red Beams, electric key
switch and more (Fig. 34).
The terminal block also features auxiliary output for
controlling other devices from your transmitter. These can
include: an alarm system, external lighting, or an automatic
gate.
Terminal connections from top down are as follows:
1. 30V PWR (+ve)
2. P.E (Safety Infra-red Beam input)
3. P.E 0V (0V for Safety Infra-red Beam)
4. GND (Common -ve ground for accessories)
5. OPERATE (Open/Stop/Close trigger)
6. AUX OUT (Auxiliary output trigger)
Step 17.2 - Remote Aerial (Part No 062177)
Some sites cause poor radio reception.
problematic areas are those where there is a large amount
of metal, like an all steel garage, or an underground car
park with large masses of steel reinforced concrete. These
issues, and others, can create radio reception issues.
Poor radio reception will be noticed by a reduction in the
operating range of the transmitters.
You can evaluate whether fi tting an external aerial will
benefi t as follows:
• test the maximum operating range of the transmitter
with the garage door closed; then
• test the maximum operating range of the transmitter
with the garage door open.
If the range improves when the door is open you can install
a remote aerial kit to improve reception.
Mount the aerial to a suitable location on the outside of
the garage. Similar to a television aerial, the better the
mounting position the better the reception will be. Where
possible, mount the aerial as high as possible, away from
masses of metal and in a line of sight position to where you
normally use your transmitter.
Step 17.3 - Electric Key Switch (Part No
062738)
An electric key switch provides an alternative to using a
transmitter. Each key turn cycles through an open/stop/close
function. The electric key switch is also an external release
mechanism - ideal for garages only with one entrance. To
connect the switch to the opener's terminal block refer to
(Fig. 35) and the Electric Key Switch's instruction sheet.
PE (IR) 0V
OSC (OPERATE)
Particularly
®
Controll-A-Door S Instruction Manual
PWR
PE (IR)
GND
AUX
30V PWR
P.E
P.E 0V
GND
OPERATE
AUX OUTPU
© Copyright 2009 B&D Doors
D Power Drive : Instruction Manual
19
Fig. 34
Fig. 35