Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for New World 60 Chim Hood
- Page 1 Chimney Hood User & Installation Instructions...
-
Page 2: Customer Care
Customer Care Thank you for choosing this appliance. Should you need any information or assistance, please call the number below and the Customer Care Centre staff will be pleased to help in any way they can. 0870 458 9662 When you dial this number you will hear a recorded message and be given a number of options. -
Page 3: Table Of Contents
Contents User’s Section ........2 - 5 Introduction . -
Page 4: User's Section
This handbook is for the following hoods: obtained. 60 Chim Hood Because of the complexity and weight 70 Chim Hood of the appliance, it is recommended 90 Chim Hood... -
Page 5: Parts Identification
Parts Identification Figure 1 removable inner chimney Viewed from grease filters extension piece underneath slider motor outer chimney extension piece light lamp covers bulb Outlet adaptor wall bracket adjustable Please note: The lights on the Chimney hood may located either at the front of the hood, or at the rear, depending on the model and size. -
Page 6: Using The Hood
Using the Hood To illuminate the cooking area under- neath the hood, push the light control button in to the “on” position. switch off, press again to return to the “off” position. To operate the hood, press the button for the required speed - select: 1 low, Figure 2A: hood controls: medium, or 3 high speed. -
Page 7: Care And Maintenance
Care & Maintenance Before cleaning or maintenance, 4. Aluminium grease filters switch off the electricity supply. supplied with this appliance. Outer casing - Stainless Steel Replacing a light bulb All external parts of the outer casing 1. Switch off the electricity supply. and visor can be safely cleaned with a clean cloth wrung out in hot soapy 2. -
Page 8: Installation
Installation Regulations and standards Mounting height Before you start please read instructions The cooker hood must be fitted at least carefully. All installations, service and 650 mm above a gas or electric hob. repair work must be in accordance If cooker / hob instructions give a with local standards and regulations. -
Page 9: Method 1: Re-Circulation
Installation Method 1: Re-circulation (dual Assembly filtration) 1. Remove the grease filters. The fan draws cooking fumes through 2. Fit the carbon filter (if supplied - the washable grease filters into the may be packed separately) by underside of the hood, then through engaging it onto the peg in the the carbon filter, to remove odours centre of the fan grille and twisting... -
Page 10: Method 2: Extraction Through An Outside Wall
Installation Method 2: Extraction through Wall vent kit and ducting an outside wall • For connecting the hood outlet The fan draws cooking fumes through adaptor to the outside wall, we the washable grease filter into the recommend that a wall vent kit is underside of the hood, then the fumes purchased from your supplier or are expelled through a duct or directly... -
Page 11: Wall Fixing
Installation Wall fixing (figures 4 & 5A / 5B) Figure 4 • Drill 8 mm diameter holes as shown. • Using the screws and dowels supplied with the appliance, fasten the wall bracket to the wall. wall bracket adjustable • Ensure that they are suitable for the type of wall where the cooker hood is to be mounted. -
Page 12: Hood Measurements
Installation Hood Measurements The below table shows the various hood measurements for this hood: Body of hood Width Depth Height Hood Name 60cm Chimney Hood 70cm Chimney Hood 90cm Chimney Hood 100cm Chimney 1000 Hood 110cm Chimney 1100 Hood The dimensions of the chimney piece (including the hood body) are as fol- lows: 250mm x 183mm x 590-960mm... -
Page 13: Electrical Connection
Installation Electrical connection Figure 6 This appliance is double insulated for Typical example of a double pole fused spur outlet safety and therefore does not require an earth connection to the mains inlet. The wires in the mains lead are coloured in accordance with the following code: Blue = neutral, Brown = live. -
Page 14: Technical Data
Technical Data Electricity supply Grease filters 230 - 240V ~ 50Hz x 2 metal filters Classification Extraction Rate (External) class II metal encased 350m 3 /H Position 3 310m 3 /H Position 2 Noise level (External Venting) 225m 3 /H Position 1 Position 3 56 dBA... -
Page 15: Customer Support
Customer Care & Service Please keep this handbook in a safe place as the information inside may be of use should you sell, or pass on the appliance. Please fill in the model number and serial number in the spaces provided below as they will assist us should you need to call. - Page 16 Stainless Steel Backplate (IF PURCHASED) Installation 1. Fix the 2 top hanging screws to the dimensions indicated. 2. Hang the backplate on the 2 top hanging screws. 3. Secure the backplate with screws through the bottom 2 fixing holes. Note: If a cooker hood is fitted above the backplate, it may be necessary to fit the filler strip, to cover any gap which may occur between backplate and hood.
- Page 18 GLEN DIMPLEX HOME APPLIANCES STONEY LANE, PRESCOT, MERSEYSIDE, L35 2XW 08 27136 01 © 08.2004...
Need help?
Do you have a question about the 60 Chim Hood and is the answer not in the manual?
Questions and answers