Motorola ET1 Integrator Manual page 56

4 - 10 ET1 Enterprise Tablet Integrator Guide
• Security Level 3 - If Security Level 2 is selected and misdecodes still occur, select this security
level. Be advised, selecting this option is an extreme measure against mis-decoding severely out
of spec bar codes. Selecting this level of security significantly impairs the decoding ability of the
scanner. If this level of security is needed, try to improve the quality of the bar codes.
•
Code39
•
Length1 - Use to set decode lengths (default - 0). See
information.
•
Length2 - Use to set decode lengths 4 (default - 55). See
information.
•
Verify Check Digit - Enable this feature to check the integrity of all Code 39 symbols to verify that the
data complies with a specified check digit algorithm. The digital scanner decodes only those Code 39
symbols that include a modulo 43 check digit. Enable this feature only if the Code 39 symbols contain
a modulo 43 check digit (default - disabled).
•
Report Check Digit - Transmit Code 39 data with or without the check digit. A check in the checkbox
indicates to send Code 39 data with check digit (default - disabled).
•
Full ASCII - Code 39 Full ASCII is a variant of Code 39 that pairs characters to encode the full ASCII
character set. To enable or disable Code 39 Full ASCII (default - disabled),
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - disabled).
•
Convert Code39 To Code32 - Code 32 is a variant of Code 39 used by the Italian pharmaceutical
industry. Scan the appropriate bar code below to enable or disable converting Code 39 to Code 32
(default - disabled).
•
Report Code32 Prefix - Scan the appropriate bar code to enable or disable adding the prefix
character "A" to all Code 32 bar codes (default - disabled).
•
Security Level - Options: Security level 0, Security Level 1, Security Level 2 and Security Level 3
(default - Security level 1).
•
Interleaved 2of5
•
Length1 - Use to set decode lengths (default - 14). See
information.
•
Length2 - Use to set decode lengths (default - 10). See
information.
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - enabled).
•
Check Digit
• No Check Digit - A check digit is not used. (default)
• USS Check Digit - Select to check the integrity of all Interleaved 2 of 5 symbols to verify the data
complies with either the Uniform Symbology Specification (USS) check digit algorithm.
• OPCC Check Digit - Select to check the integrity of all Interleaved 2 of 5 symbols to verify the data
complies with either the Optical Product Code Council (OPCC) check digit algorithm.
•
Report Check Digit - Transmit Interleaved 2 of 5 data with or without the check digit. A check in the
checkbox indicates to send I2of5 data with check digit (default - disabled).
•
Convert ITF-14 To EAN13 - Convert 14-character Interleaved 2 of 5 bar codes to EAN-13, and
transmit as EAN-13. The Interleaved 2 of 5 bar code must be enabled and must have a leading zero
and a valid EAN-13 check digit. A check in the checkbox indicates that the option is enabled (default -
disabled).
Decode Lengths on page 4-13
Decode Lengths on page 4-13
Decode Lengths on page 4-13
Decode Lengths on page 4-13
for more
for more
for more
for more