NAD M22 Owner's Manual
  1. Manuals
  2. Brands
  3. NAD Manuals
  4. Amplifier
  5. M22
  6. Owner's manual

NAD M22 Owner's Manual

Stereo power amplifier
Hide thumbs Also See for M22:
Table of Contents

Advertisement

Quick Links

See also: Service Manual
M22
®
Stereo Power Amplifier
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M22 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for NAD M22

Summary of Contents for NAD M22

  • Page 1 ® Stereo Power Amplifier Owner’s Manual...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS 14 Outdoor Antenna Grounding - If an outside antenna or cable system SAVE THESE INSTRUCTIONS FOR LATER USE. is connected to the product, be sure the antenna or cable system is FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO grounded so as to provide some protection against voltage surges EQUIPMENT.
  • Page 3 (including amplifiers) that produce heat. CAUTION Changes or modifications to this equipment not expressly approved by NAD Electronics for compliance could void the user’ s authority to operate this WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS equipment.
  • Page 4 RECORD YOUR MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) The model and serial number of your new M22 are located on the back of the cabinet. For your future convenience, we suggest that you record these numbers here: Model no: .

  • Page 5: Getting Started

    Power up the external source ahead of the M22. them to their corresponding foot shoe. Refer to the illustration below. 7 Set to ON the rear panel POWER switch of M22. The M22 goes to standby mode as shown by the amber status condition of the Power indicator.

  • Page 6: Identification Of Controls

    The rear panel POWER switch must be set to ON position. AUTO STANDBY The M22 can be setup to automatically go to standby mode if there is no active source input within 30 minutes. Auto standby mode can be enabled or disabled by the following steps.

  • Page 7: Rear Panel

    50/60Hz © NAD M22 ATTENTION! Ensure that the M22 is unplugged before making any connections. It is also advisable to power-down or unplug all associated components while making or breaking any signal or AC power connections. 1 BALANCED 4 PROTECT • Use the BALANCED analog audio input of the M22 if the external...

  • Page 8: Ac Mains Input

    12V trigger output to use this feature. from standby mode. • If you intend not to use the M22 for long periods of time (such as when on vacation), switch off the POWER switch. • The o (Standby) button cannot activate the M22 with the rear...

  • Page 9: Troubleshooting

    POSSIBLE SOLUTIONS No power. • Mains power cord unplugged from mains • Connect the mains power cord to M22’s AC mains power source or from M22’s AC mains input. input and then plug into a mains power source. • Power switch is off.

  • Page 10: Overall Specifications

    * - Gross dimension include feet, front panel and rear panel extensions (knobs, buttons, speaker terminals, sub fascia, etc.) NAD SHALL NOT BE HELD LIABLE FOR ANY TECHNICAL OR USER INTERFACE DISCREPANCIES IN THIS MANUAL. THE M22 OWNER’S MANUAL MAY BE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE. CHECK OUT WWW.
  • Page 12 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

Table of Contents