Sony LMD-2451MT Instructions For Use Manual page 35

I/P MODE
Press the button to set the delay by the picture
processing to the minimum level when interlace signal is
input. The mode switches in the sequence INTER-
FIELD t LINE DOUBLER t FIELD MERGE with
every press of the button (see "I/P MODE" on page 32).
MIRROR IMAGE
Press the assigned button to flip and display the video
signal horizontally. This function is not available for the
PRESET 1 signal and the multi display.
MONO
Press the assigned button to display a monochrome
picture. When the buttons is pressed again, the monitor
switches automatically to color mode.
APA (Auto Pixel Alignment)
Press to adjust the picture automatically to maximum
clarity for the signal input to the HD15 input connector.
For finer according to the input signal, see "DOT
PHASE" on page 31.
When the menu screen or the multi display is displayed,
APA does not function.
Note
If the APA operation does not finish correctly depending
on the input signal, adjust DOT PHASE (page 31).
BLUE ONLY
Press the assigned button to eliminate the red and green
signals. Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation of
VCR noise.
2D/3D SELECT
Press the button to switch from 2D display mode to 3D
display mode. For detailed 3D display settings, select
2D/3D SELECT under the 3D SETTING menu.
Pressing the button again switches to 2D display mode.
Install BKM-250TG with a serial number 7100001 or
later to display HD-SDI signal in 3D.
3D SIGNAL FORMAT
Press the button to set input signal format for 3D display.
The mode switches in the sequence 3G-B t DUAL t
SEQUENTIAL t SIDE BY SIDE t LINE BY LINE
t AUTO with every press of the button (see "3D
SIGNAL FORMAT" on page 37). Install BKM-250TG
with a serial number 7100001 or later to display HD-
SDI signal in 3D.
Note
This function is only available in 3D display mode.
CHECKERBOARD
When displaying 2D images, press the button to display
input signals from the IN (INPUT)-1 and IN (INPUT)-2
connectors in grid pattern. Two input signals can be
monitored on the screen at a time. Pressing the button
again displays the input signals in default pattern. Install
BKM-250TG with a serial number 7100001 or later to
display HD-SDI signal in 3D.
Note
This function is only available in 2D display mode.
Checkerboard display
Left signal (L)
Checkerboard display
L/R SWITCH
Press the button to quickly switch between a dual-stream
HD-SDI signal from IN (INPUT)-1 connector on BKM-
250TG and one from IN (INPUT)-2 connector. You can
easily compare the two input signals. Install BKM-
250TG with a serial number 7100001 or later to display
HD-SDI signal in 3D.
Note
This function is only available in 2D display mode.
HOROPTER CHECK
Press the button to select display formats in monitoring
left/right signals for 3D image display. Select the desired
format from HOROPTER CHECK (page 38) under the
3D SETTING menu. Pressing the button again switches
to default display format. Install BKM-250TG with a
serial number 7100001 or later to display HD-SDI signal
in 3D.
Right signal (R)
35
Adjustment Using the Menus