Honeywell Evohome Installation Manual page 16

14
Radiator Controllers (HR92)
evohome
Controller
If you are NOT following
GUIDED CONFIGURATION
follow these steps on your
evohome Controller display
first:
1. Press and hold 'Settings'
for 3 seconds
2. Press the green tick
3. Press ADD ZONE
4. Press the zone you want
to add the Radiator
Controller to
5. Rename the zone if
required and/or press the
green tick
6. Press RADIATOR VALVE
7. If you want to control the
zone temperature with the
evohome Controller (which
needs to be located in
that zone) press YES,
otherwise press NO.
You must repeat these steps
for each radiator controller.
1 2
Step 3: Power up and bind devices
Power up and bind Radiator Controllers
(HR92) – Your evo Zone Kit
Bind the Radiator Controllers (HR92)
Remove the circular top cover
1
Open the battery clip and insert the AA batteries supplied
2
Close the clip and replace the cover
3
Press the
4
Press and hold the
5
5 seconds until it says BIND
Press the
6
You should receive a SUCCESS message on the
7
evohome Controller (if not go back and re-bind)
The name of the allocated zone should appear on
8
the HR92 display when you press the
Either press the green tick
9
radiator to the zone. Or press the red cross
you don't need to add another radiator to the zone
4
PRESS
ONCE
button once − it should say UNBOUND
button for a further
button once – it should say BINDING
to add another
5 6
PRESS
5 SEC
button
if
PRESS
ONCE