Page 2
900CD series visit our website at www.CurrieTech.com scooter scooter scooter scooter Minimum Rider IMPoRTanT - Activate your warranty by registering your new Currie 13 years old 13 years old 13 years old 13 years old Technologies ® product within 10 days of purchase by visiting our website at www.CurrieTech.com.
Page 3
® ® Currie Technologies Currie Technologies section 2 - safeTY GUIDelInes WaRnInG never operate this product without proper training lIMITaTIons of safeTY anD WaRnInG noTICes or instructions. WaRnInG This owner’s manual includes important safety WaRnInG Children under 13 years old should never operate these guidelines and maintenance instructions.
Page 4
® ® Currie Technologies Currie Technologies Avoid excessive speed associated with downhill riding. Always drive slowly baTTeRY CHaRGeR and pay extra attention when operating on unfamiliar terrain. Always be alert The charger and charger port should be regularly inspected for damage to changing terrain conditions when operating this product.
Page 5
® ® Currie Technologies Currie Technologies sToPPInG Install the front wheel (certain models will have the front wheel To slow down or come to a stop, allow the throttle to completely return to its already installed) being sure to properly install the safety washers.
Page 6
® ® Currie Technologies Currie Technologies Open the stem hinge to section 4 - RePaIR & MaInTenanCe access the steerer bolt (6mm Allen Bolt or 13mm IMPoRTanT: Some adult assembly required. Hex Bolt). HanDlebaR asseMblY anD aDjUsTMenT Electro-Drive™ scooters are equipped with an folding stem hinge. Take care not to pinch your hands or fingers in the hinge when you are folding and locking the handlebar in place.
Page 7
If you are unable to lock the handlebar folding hinge properly, or its Quick- Release lever, or properly secure the two main handlebar parts to the scooter, DO NOT RIDE THE SCOOTER. Contact Currie Technologies ® Customer Service at 1-800-377-4532 for further instructions.
Page 8
QR (Quick Release) Lever. WaRnInG Use only a Currie Authorized Smart Charger to charge Open the QR lever (Ref Photo A) and the batteries. Using any other charger may damage the adjust the 10mm nut underneath the batteries and void your warranty.
“D” ring deck retention fUse screw. In the event of an overload the fuse will pop and need to be replaced. In this instance replace only with approved part from Currie Technologies ® WaRnInG Risk of fire, Do not bypass fuse.
Page 10
Turn the power switch “ON” and resume throttle properly, DO NOT RIDE YOUR SCOOTER. Con- riding. tact Currie Technologies Customer Service for information and instructions at 1-800-377-4532. WaRnInG The scooter will shut down due to over-heating caused by excessive stress on the motor (i.e.
Page 11
Take your scooter to a qualified scooter scooter to a safe, controlled stop. or bicycle mechanic for proper service, or call Currie Technologies ® Customer Service at: 1-800-377-4532.
® ® Currie Technologies Currie Technologies CHaIn aDjUsTMenT watching the chain. Be sure that the rear wheel is turning smoothly and the chain does not try to run off the rear sprocket in either direc- The chain can stretch during use or may occasionally come out of adjust- tion.
® ® Currie Technologies Currie Technologies WHeel ReMoval ReaR WHeel & DRIve asseMblY ReMoval fRonT WHeel ReMoval 300, 4.0 anD 400 300, 4.0, 400, 500CD, 650CD, 750CD seRIes sCooTeRs anD 900CD seRIes sCooTeRs Turn the power switch to the Detach the V-Brake, if your “OFF”...
Page 14
® ® Currie Technologies Currie Technologies Loosen and remove both 15mm Set the motor into the empty axle nuts. (Ref Photo E) battery tray. Loosen and remove both 10mm Loosen and remove both axle chain tensioners. (Ref Photo F) nuts with a 15mm wrench (Ref Push the wheel all the way for- Photo B).
® ® Currie Technologies Currie Technologies WHeel InsTallaTIon ReaR WHeel InsTallaTIon fRonT WHeel InsTallaTIon: 300, 4.0 anD 400 seRIes sCooTeRs 300, 4.0, 400, 500CD, 650CD, 750CD The order of this installation is very important. Start with the chain pushed anD 900CD seRIes sCooTeRs over the frame so it can be placed on the large sprocket after the wheel is in place.
Page 16
® ® Currie Technologies Currie Technologies flaT TIRe RePaIR WaRnInG Proper braking performance is critical for safe riding. fRonT WHeel Currie Technologies ® strongly recommends that brake(s) be adjusted only by a trained scooter or bicycle technician. 4.0 anD 400 seRIes sCooTeRs...
Page 17
® ® Currie Technologies Currie Technologies (if your scooter is equipped). To reassemble the front wheel, first slightly inflate the tube to allow it Slide the axle through one half of the rim, and place the center (lon- to take shape then install into the tire.
Page 18
Parts can be purchased directly from Currie Technologies ® by calling You might be surprised to hear that you can ride any Currie electric scooter 1-800-377-4532. in pretty much the same conditions you would expect to ride a normal bicycle or scooter. In fact as long as you don’t submerge the electrical * Keep a copy of your purchase receipt on hand and available in case you components you’ll be fine.
Page 19
Never operate this product barefoot or in sandals as this increases the risk of _____________________________________________________________ □ injury. Always obey all local traffic laws _____________________________________________________________ _____________________________________________________________ ___________________________________________________________ OM Chain Drive Scooters - 2012.indd www.CurrieTech.com Modified 05/25/2012 OM eZip Chain Drive Scooters 2010 rev-1...
Need help?
Do you have a question about the eZip and is the answer not in the manual?
Questions and answers