Removal 3
TRANSPORT ASSY A4 (PL14.2.1)
In the following steps, the details of Steps 1 and 2 are omitted because they are described earlier in this
chapter. Go to the steps in parentheses to execute the necessary steps, and then go to Step 3 onward.
1)
Remove the TRAY STACKER. (Removal 1)
2)
Remove the FINISHER ASSY. (Removal 2)
3)-1
3)
Remove the one clamp that fixes the harness of the TRANSPORT ASSY A4 (PL14.2.1) to the
printer.
When performing the following step, use caution not to drop the BRACKET ASSY GUIDE
ADD.
4)
Remove the two SCREW M4 STEELs (PL14.1.8) while holding the BRACKET ASSY GUIDE ADD
(PL14.1.9).
5)
Remove the BRACKET ASSY GUIDE ADD.
Continues to the next page.
Finisher Service Manual
Version 2 2009.06.10
Chapter 3 Removal and Replacement Procedures (RRPs)
3)-1
3)-2
4)
3 - 12
4)
5)
Tbt03505KB