Advertisement

Home Station
Fibra Óptica
Freedom
in a box.
Installation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Home Station Fibra Óptica and is the answer not in the manual?

Questions and answers

Summary of Contents for movistar Home Station Fibra Óptica

  • Page 1 Home Station Fibra Óptica Freedom in a box. Installation Guide...
  • Page 3: Box Contents

    This guide explains the installation process for the “Home Station Fibra Óptica”. Follow these guidelines step by step. Box contents (1) “Home Station (2) Power (3) Two Ethernet Fibra Óptica” supply cables (4) Installation (5) Advanced (6) Guarantee guide options CD card...
  • Page 4: Connecting To The Internet

    Connecting to the Internet 1. Connecting the Power Supply Plug the power supply into the mains and into the DC12v-1.67A connector on the “Home Station Fibra Óptica”. The rear panel of the “Home Station Fibra Óptica” contains the connectors and the switch shown in the figure below.
  • Page 5 The side panels of the “Home Station Fibra Óptica” contain a USB port and three buttons labelled WPS, Reset and WIFI. The following table shows a description of the connectors and buttons shown above: Connector Description DC12V Power cable connector On/Off On/Off switch Reset...
  • Page 6 2 Switching On the “Home Station Fibra Óptica” Switch on the “Home Station Fibra Óptica” by pressing the switch to the ON position. The table below explains the meaning of each of the LED indicators: Indicador luminoso Descripción Power On (fixed green): The router is switched on. Flashing (green/red): Initialisation process.
  • Page 7 Eth. 1 – Eth.2 - Eth. 3 – Eth.4 switches. • The Wireless LED will light up green if the wireless inter- face is on. It will also flash when there is any activity on this interface. • The USB LED shows if there is activity on the USB con- nection. Movistar may at any point, particularly after initial installation, automatically and remotely execute software updating on your device thus providing a better service. During this process the Power LED located on the front panel will flash in green.
  • Page 8: Wireless Network

    Warning: Please do not switch off your device or disconnect it from the mains while this updating is being carried out: you may seriously damage the system. This process can take some 10 to 11 minutes after which your device will automatically restart. At this point the Power LED will flash in red and, once the process has successfully finished, then switch to a steady green.
  • Page 9 You will need to configure the wireless client for your PC using these parameters. For more information, see the following page. 4.1.1 WPS Connection The “Home Station Fibra Óptica” is also compatible with the wireless connection secure ex- change protocol WPS. It is important to take into account that, in order to use this wireless association method, the wireless client (the system used to connect to the “Home Station Fibra Óptica”) must be WPS-compatible.
  • Page 10 4.2 Connecting via Cable Connect one end of one of the yellow Ethernet cables to the Ethernet card in your PC and connect the other end to one of the connectors on the “Home Station Fibra Óptica” labelled Eth 1-4. The other yellow Ethernet cable should connect the ONT to the WAN port of the “Home Station Fibra Óptica”.
  • Page 11 Once your PC has been connected to your Optical Fiber, we recommend you protect it from Internet attacks and intrusions. If you wish, you can sign up for these services (Antivirus PC, Anti-Intrusos PC, Pack Seguridad PC…) via www.movistar.es, by calling 1004 or through your usual contact method.
  • Page 12: Troubleshooting

    Troubleshooting Problem Solution None of the LED indicators light up Check that the “Home Station Fibra Óptica” is connected to the mains and that the ON button is pressed. The Ethernet LED indicator does not light Verify that the LAN cable is connected at both ends and that all the devices are swit- ched on.
  • Page 13 Problem Solution The wireless network keeps getting discon- If there are other active wireless networks nected in the same area, we recommend you confi- gure the networks with a separation of 4 or 5 channels. If this is not possible, select the least saturated channel.
  • Page 14 “Home Station Fibra Óptica”. If you decide to change your password, Movistar management system will stop having any control over the “Home Station Fibra Óptica” and, therefore, the configuration operations from the portal will be di- sabled.
  • Page 15: Additional Information

    Additional Information Recycling We would like to thank you for placing your trust in Movistar and purchasing one of our devices. For any clarification, question or Never dispose of your “Home Station Fibra complaint, please contact any of the fo- Óptica”...
  • Page 16: Customer Support

    Customer Support The customer support service is available via telephone and Internet. For more information regarding Optical Fiber visit: www.movistar.es/router Movistar Technical Support Private customers: 1004 SMEs and professionals: 900 10 10 10 Customer support for executing the guarantee of the device Private customers: 1004 SMEs and professionals: 900 10 10 10 For more information, visit: www.movistar.es/router...
  • Page 17 DECLARATION OF CONFORMITY According to the technical specifications applicable on the day as stated in Directive 99/05/CE of the European Parliament and Council dated 9th March 1999, adopted by Spanish legislation by Royal De- cree 1890/2000 of 20th November 2000 and, specifically, according to: LVD 72/23 Directive modified by 93/68/CE and by the Electromagnetic Compatibility Directive 89/336/CE modified by Directive 92/31/CE Identification of the informant and the manufacturer...
  • Page 18 Glossary Antivirus: Dynamic/static addressing: Programmes designed for detecting and This defines the way in which Movistar assig- removing computer viruses and other mali- ns an IP address to your line. If your “Home cious programmes. Station Fibra Óptica” is assigned a different...
  • Page 19 PCMCIA: WPS: A hardware element generally used in laptop Standard promoted by the Wi-Fi Alliance computers for expanding their capacity. The aimed at creating secure WLAN networks. most common examples are wireless adap- WPS is not a security mechanism per se, but tors.
  • Page 20 More information: 1004 (from a mobile or land line) +34 699 991 004 (from abroad) Movistar shops www.movistar.es Version: 1.0 Equipment supplied by: VAT Number: A-28877579 REI-RAEE Registry Number: 000443...

Table of Contents

Save PDF