Others; Warning Messages; Error Messages - JVC KA-MR100G Instructions Manual

Others

Warning Messages

When warning messages appear on the LCD panel, take the
following actions.
WRITE
Warning Messages
PROTECT!
Message
CLOCK Appears when the clock is not set.
SETUP Action: Set the clock when the [CLOCK1]
MENU setting screen appears.
WRITE Appears when the write-protect switch of
PROTECT! the SxS memory card is set to the "WP"
end.
Action: Set the write-protect switch to AOffB
before recording or deleting a clip.
CARD FULL! Appears when there is no more space left
on the SxS memory card.
Action: Take any of the following actions.
● Use an SxS memory card with sufficient
space.
● Delete unwanted clips or format the card
to create space.
OPERATION Appears when buttons other than the
LOCK ! [MENU] button is pressed with the
[OPERATION] menu set to ALOCKB.
Action: Change the [OPERATION] menu
setting to AUNLOCKB.

Error Messages

Battery and Signal Error Messages
An error message appears at the first line of the LCD panel
display when the battery is weak or when there is an input
signal error. When an error message appears, take the
following actions.
Message
BAT. Appears when the remaining battery level
ALARM ! is insufficient.
Action: Charge the battery.
SHUT Appears immediately before the battery
DOWN ! runs out completely. The memory recorder
will shut down a few seconds after the
message is displayed.
Action: Charge the battery.
NO SIGNAL ! Appears when there is no signal input.
(*1) Action: Check the connection of the
IEEE1394 cable and the camcorder
settings.
Other Appears when the format of input signals is
SIGNAL (*1) different from that of the memory recorder.
Action: Make sure that the memory
recorder settings are consistent with those
of the camcorder. (A Page 9)
(*1) Appears during the recording or stop mode.
Description
Description
Card Error Messages
When an SxS memory card incompatible with the memory
recorder is detected, an AERROR CARD!B message and a
message indicating the cause of the card error will appear
alternately at the first line of the LCD panel display. (For
approximately two seconds) When an error message
appears, take the following actions.
Message
NO Appears when a media not supported by
SUPPORT! the memory recorder is inserted.
Action: Replace it with a recommended
SxS memory card.
FORMAT! Appears when the card has already been
formatted by another device.
Action: Execute AFORMATB using this
memory recorder.
"Menu screen's [MEDIA]->[FORMAT]
settings" (A Page 13)
CARD Appears when errors are found in the clip.
CHANGE Action: Execute ARESTOREB or
AFORMATB using this memory recorder. If
doing so does not eliminate the error, it
may be due to malfunction of the SxS
memory card. Replace the SxS memory
card.
RESTORE ! Appears when the clip may be damaged.
Action: Execute ARESTOREB using this
memory recorder.
Card error message appears when the following operations
are performed.
● When an SxS memory card is inserted
● When power is turned on with an SxS memory card
inserted
When in the stop, standby or still mode
Status screen (stop or standby)
<LCD Panel>
Clip selection screen (still)
<LCD Panel>
When in the menu screen display
<LCD Panel>
Description
14