1. Press BYPASS and enter the MASTER CODE. 2. Scroll up/down to find the sensor you wish to put back in service. 3. Press OK and the display will no longer show the word “Bypassed”. GE Simon XT Quick User Guide Page 2...
10. Press OK again; the display will now flash AM/PM. 11. Scroll up/down to set AM/PM. 12. Press OK to accept. The display will now show current time and will stop flashing. 13. Press STATUS twice to exit programming. GE Simon XT Quick User Guide Page 3...
4. While letting the face hang down, slightly pull apart the tabs holding the battery in place. 5. Remove the battery, and observing correct polarity, replace. 6. Replace cover. 7. Plug unit back into outlet. 8. Press STATUS button GE Simon XT Quick User Guide Page 4...
DISARM. If the trouble condition was a low system battery, perform a sensor test. The STATUS light should turn off if all trouble conditions have been corrected. GE Simon XT Quick User Guide Page 5...