Preface - Requirements; Overview; Fcc Registration Numbers; Key Operation - Panasonic DBS 576HD Technical Manual

Preface - Requirements

OVERVIEW

This section provides information the telephone company may require before providing you with service. Additionally, important
notices and warnings are listed for your knowledge and safety.

FCC REGISTRATION NUMBERS

The Federal Communications Commission (FCC) has established rules which permit the DBS 576 HD to be directly connected
to the telephone network. To ensure that the DBS 576 HD complies with these FCC rules, the local telephone company may
ask you for the FCC registration numbers when attaching their equipment to the DBS 576 HD.
The DBS 576 HD can be configured as either a KEY or Hybrid telephone system. The way you register your system depends
on how you use the system. First, determine how you will be operating the system, and then refer to the table below for FCC
registration numbers. The following tables also list additional information that may be required by your local telephone
company.

Key Operation

A KEY system requires you to manually select an outside line to make an outgoing call. Typically, line keys on a
telephone represent the specific lines that are attached to the system (for example, Key 1 represents line 1; Key 2
represents line 2; etc.).

Hybrid Operation

A Hybrid system allows automatic selection of outgoing lines, such as pooled key operation, dial access, least cost
routing (LCR), etc. (for example, depress a key to select from a pool of lines; or dial 9 to select an outside line).
REGISTRATION INFORMATION
System
DBS 576 HD KEY
DBS 576 HD HYBRID
* The Ringer Equivalence Number (REN) is useful to determine the quantity of devices that you may connect to your telephone
line and still have all of those devices ring when your number is called. In most, but not all areas, the sum of the RENs of all
devices on any one line should not exceed five (5). To be certain of the number of devices you may connect to your line, as
determined by the REN, you should call your telephone company to determine the maximum REN for your calling area.

INTERFACE INFORMATION

The DBS 576 HD offers several types of interface cards that allow you to connect to different circuits offered by your telephone
company. Listed below is additional information that the telephone company may require before providing you with these
different services.
REGISTRATION INFORMATION
Port Type Type of Interface
Loop Start Trunk 2-wire loop
Ground Start Trunk 2-wire loop
DID Trunk 2-wire DID
T-1 Trunk T-1
ISDN PRI
ISDN BRI
E&M Type I 2-wire
Type I 4-wire
Type II 2-wire
Type II 4-wire
Type V 2-wire
Operation Ringer Equivalence
Loop Start: 0.5B/2.8DC*
DID: 0.0B*
Loop Start: 0.5B/2.8DC*
DID: 0.0B*
USOC Jack Connector Service Order Code
RJ14 2W
RJ14 2W
RJ21X
RJ48C
RJ48C
RJ11 / RJ45
RJ1CX
Network Address
Signaling Code FCC Registration
E JNVUSA-32340-KF-E
E JNVUSA-32339-MF-E
Facility Interface Code
9.0F 02LS2
9.0F 02GS2
AS.2 02RV2-T
6.0P 04DU9-DN, 04DU9-1SN
6.0P 04DU9-DN, 04DU9-1SN
6.0P 02IS5
9.0F TL11M
TL31M
TL12M
TL32M
Preface - Requirements 3