Installation; Removal - Alpine CDE-143EBT Owner's Manual

IMPORTANT
Please record the serial number of your unit in the space provided
below and keep it as a permanent record. The serial number or the
engraved serial number is located on the bottom of the unit.
SERIAL NUMBER: [
INSTALLATION DATE: [
INSTALLATION TECHNICIAN: [
PLACE OF PURCHASE: [

Installation

CAUTION
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
Less than 35°
1
Remove the mounting sleeve from the main unit (Refer to
"Removal" on page 36).
Mounting Sleeve (Included)
Pressure Plates*
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
Reinforce the head unit with the metal mounting strap
(not supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (
vehicle's chassis.
Connect each input lead coming from an amplifier to the
corresponding output lead coming from the left rear of the
CDE-143EBT/CDE-143EBTTH/UTE-42EBT/UTE-42EBTTH. Connect
all other leads of the CDE-143EBT/CDE-143EBTTH/UTE-42EBT/
UTE-42EBTTH according to details described in the
CONNECTIONS section.
36
-EN
Detachable Front
Panel
Dashboard
This unit
*1
) already attached to the
Hex Nut (M5)
]
]
]
Metal
]
Mounting
Strap
Ground Lead
Note
• For the screw marked "
mounting location.
3
Slide the CDE-143EBT/CDE-143EBTTH/UTE-42EBT/
UTE-42EBTTH into the dashboard until it clicks. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install the
detachable front panel.

Removal

1
Remove the detachable front panel.
2
Insert the bracket keys into the unit, along the guides on
either side. The unit can now be removed from the
mounting sleeve.
3
Pull the unit out, keeping it unlocked as you do so.
JAPANESE CAR
Ground Lead
3
*
Note
• Secure the ground lead of the unit to a clean metal spot using a screw
*3
( ) already attached to the vehicle's chassis.
Screw
2
*
Bolt Stud
1
*
This unit
Chassis
*2
", use an appropriate screw for the chosen
This unit
Bracket keys
(Included)
Front Frame
Screws (M5 × 8)
This unit
(Included)
Mounting Bracket