Connect Wires - Philips CED1800BT User Manual

Connect wires

Note
Make sure that all loose leads are insulated with
electrical tape.
Consult a professional to connect wires as instructed
below.
Before connection, check the car's wiring carefully.
1
Connect the ISO male connectors.
ISO male
connectors
a Green strip, black-
edged green strip
b White strip, black-
edged white strip
c Gray strip, black-
edged gray strip
d Purple strip, black-
edged purple strip
e Red strip
f Blue strip
g White-edged blue
strip
h Black strip
i Yellow strip
Connect to
Rear left speaker
Front left speaker
Front right speaker
Rear right speaker
Ignition key +12V
DC when ON/
ACC
Motor/electric
antenna relay
control lead
control lead
Ground
The +12V car
battery which is
energized at all times
2
Connect other wires if necessary.
Caution
To avoid an accident, the driver must not watch video
while driving. By design, this system disallows watching
video during drive. Park your car in a safe place and
engage the parking brake before watching video.
Note
When the parking brake of your vehicle is not engaged,
the video blocking system is activated. It blocks the
display of front video source only.
If the system is not properly connected with the
parking brake control module of your vehicle, video
signals will be blocked by the system, with the below
message displayed on the TFT.
Connectors and
sockets on rear panel
1 For ISO male
connectors
REAR OUT R (Red
2
socket)
3 AV-IN R (Red socket)
AV-IN L (White
4
socket)
REAR OUT L (White
5
socket)
External sockets
or connectors
As indicated
above
Rear right
speaker
Right audio
channel output
socket of an
external player
Left audio
channel output
socket of an
external player
Rear left speaker
EN 7