Bosch AMAX 2100 Installation Manual page 142

142 en | Troubleshooting
7
7
7
7
7
8
8
Table 10.1: Types of fault or tamper conditions
* In case one or more faults occur in this category
Fault Description
1 - Accessory Module Failure
–
Condition:
No communication with the DX4020 / ITS-DX4020G if DX4020 / ITS-DX4020G is available.
Restore:
4
Supervise:
1.
2.
P
–
Condition:
No communication with DX3010 if DX3010 is available.
Restore:
4
Supervise:
1.
2.
P
–
Condition:
No communication with DX2010 if DX2010 is available.
Restore:
4
Supervise:
2014.11 | 02 | F.01U.267.112
6 1
7
7 1
8
8 1 – 8
1 - 16
Network/IP Module 1-2 Failure
Restore the communication with DX4020 / ITS - DX4020G to a normal condition and reset
the fault. For more information, refer to DX4020-G, page 22.
Report the DX4020 / ITS - DX4020G fault to configured destination on address 124 when
the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
Output Expansion Module 1-2 Failure
Restore the communication with DX3010 to a normal condition and reset the fault. For
more information, refer to DX3010, page 18.
Report the DX3010 fault to configured destination on address 140 when the fault is
detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
Input Expansion Module 1-6 Failure
Restore the communication with DX2010 to a normal condition and reset the fault. For
more information, refer to DX2010, page 16.
Keypad Lock out
RF receiver tamper
RF receiver tamper
RF repeater tamper
RF repeater tamper
External failure
External fault zone 1 - 16
Installation Guide
AMAX 2100 / 3000 / 4000
Bosch Sicherheitsysteme GmbH