Setting Water Hardness; Setting Temperature - Nivona CafeRomatica NICR7 Series Operating Instructions Manual

The "Setting Filter" message will appear on the display.
➔ Turn the Right rotary knob to "Setting Exit". Now press the Right rotary knob.
The first menu level will appear on the display. The machine is now ready for use.
WARNING! Please do not forget to select a water hardness setting, if you intend to operate without a
filter (see Point 3.2).
3.2 Water hardness
Sooner or later (depending on local water hardness conditions), your machine will require descaling.
In order that the machine can tell you when descaling is necessary, you must select the correct water
hardness setting before using the machine for the first time.
When using a filter, provided the correct settings have been made (see Point 3.1 above), water
hardness will automatically be set inside the machine to level 1. Before leaving the factory, water
hardness is set to LEVEL 3.
Start by testing the quality of the water to be used in your machine with the test strip provided:
➔ Dip the test strip briefly into your water sample and then shake off any excess water.
➔ Wait for approx. one minute and then take your reading by counting the red points on the test
strip.
➔ The level settings are indicated as follows:
Test Strip / Degree of Hardness = Display
1 red point / 1–7° = LEVEL 1
2 red points / 8–14° = LEVEL 2
3 red points / 15–21° = LEVEL 3
4 red points / >21° = LEVEL 4
Note: If there are no red points on the strip, set your machine to level 1.
Set your machine for water hardness as follows:
➔ Turn the Right rotary knob to "Setting". Now press the Right rotary knob.
➔ Turn the Right rotary knob to "Setting Water Hardness". Now press the Right rotary knob.
The machine's current water hardness setting will appear on the display.
➔ Now press the Right rotary knob.
The machine's current water hardness setting will flash intermittently on the display screen.
➔ Turn the Right rotary knob to select the required water hardness level. Now press the Right rotary
knob.
➔ Turn the Right rotary knob to "Water Hardness Exit". Now press the Right rotary knob.
The "Setting Water Hardness" message will appear on the display.
➔ Turn the Right rotary knob to "Setting Exit". Now press the Right rotary knob.
The first menu level will appear on the display. The machine is now ready for use.

3.3 Setting temperature

Coffee temperature can be set to "normal", "high", "maximum" or "individual", to suit your personal
requirements. Your machine's standard factory setting is "high". Once you have set the temperature,
as described below, this will be the setting used for all speciality coffees.
Alternatively, you can use the "individual" setting to allow you to select a different temperature for
each speciality coffee (see Point 4). Choose the "individual" setting in this menu as follows:
➔ Turn the Right rotary knob to "Setting". Now press the Right rotary knob.
➔ Turn the Right rotary knob to "Setting Temperature". Now press the Right rotary knob.
The machine's current temperature setting will appear on the display.
3. Selecting / altering the basic settings
GB
51