Leviton Single Pole and 3-Way Switch Installation Instructions

PK-93604-10-00-0A
WARNINGS AND CAUTIONS:
• To be installed and/or used in accordance with appropriate electrical codes and regulations.
• To avoid fi re, shock or death, TURN OFF POWER at circuit breaker or fuse. Test that
power is off before wiring.
• Use these devices only with copper or copper clad wire. With aluminum wire use only
devices marked CO/ALR or CU/AL.
• NOTE: The following diagrams apply to both Standard Style and Decora Style
Combination Devices.
Tools needed to install Switch:
• Slotted, Phillips, or Robertson Screwdriver
INSTALLING SWITCH:
NOTE: Use check boxes when Steps are completed.
WARNING: To avoid fi re, shock, or death; TURN OFF POWER at circuit
Step 1
breaker or fuse and test that power is off before wiring!
Identify Wall Box Wiring:
Step 2
To install this combination switch, the following wires must be present
inside wall box.

SINGLE LINE HOT

(Common Feed)
1. Line (Hot-System)
2. Neutral (Optional)
3. Ground
4. Load - Single Pole
5. Travelers (To other 3-Way Switch)
NOTE: Neutral and ground connections may differ in your application. Ensure the
device is properly grounded to system. If the wiring in the wall box does not
resemble any of these confi gurations, consult a qualifi ed electrician.
Single Pole and 3-Way Switch
Standard Style Cat. No. 5241
Decora Style Cat. No. 5641
Rated: 15A-120/277VAC
INSTALLATION INSTRUCTIONS
• Wire Cutters
TWO LINE HOT
(Separate Feed))
1. Line 1 (Hot-System)
2. Line 2 (Hot-System)
3. Neutral (Optional)
4. Ground
5. Load - Single Pole
6. Travelers (To other 3-Way Switch)
Standard Style Switch
Cat. No. 5241
3-Way
Single pole
Prepare Wires:
Step 3
Remove 5/8" (1.6 cm) of insulation from each wire in the wall box.
Strip 5/8"
(1.6 cm)
NOTE: For separate feed (2 circuit)
operation only: The break-off
fi n located between the black
screws should be removed
before wiring. Using a standard
slotted screwdriver, bend fi n
until it breaks off.
Installing your Switch:
Step 4
COMMON FEED (Single Line Hot)
Single pole switch and 3-way switch on the same circuit. Light(s)
controlled by single pole switch, other light(s) controlled by 3-way switch
and another 3-way switch at a different location.
Decora Style Switch
Cat. No. 5641
3-Way
Single pole
5/8"
(1.6 cm)
Strip Gage
SINGLE LINE HOT
(Common Feed)
1. Line (Hot-System)
2. Neutral (Optional)
3. Ground
4. Load - Single Pole
5. Travelers (To other 3-Way Switch)