Crispers And Pans - GE 23 Owner's Manual And Installation

About the crispers and pans.
Not all features are on all models.
H I L O
About crisper removal.
Not all features are on all models.
Fruit and Vegetable Crispers
Excess water that may accumulate in the
bottom of the drawers should be wiped dry.
On some models, the bottom drawer has
full extension slides that allow full access
to the drawer.
Adjustable Humidity Crispers
Slide the control all the way to the
HI setting to provide high humidity
recommended for most vegetables.
Convertible Meat Pan
The convertible meat pan has its own
cold air duct to allow a stream of cold air
from the freezer compartment to flow to
the pan.
The variable temperature control regulates
the airflow from the Climate Keeper.
Crisper Removal
The top crispers can easily be removed by
pulling the drawer straight out and lifting
the drawer up and over the stop location.
If the door prevents you from taking out
the drawers, first try to remove the door
bins. If this does not offer enough
clearance, the refrigerator will need to
be rolled forward until the door opens
enough to slide the drawers out. In some
cases, when you roll the refrigerator out,
you will need to move the refrigerator
to the left or right as you roll it out.
To remove the bottom crisper:
Pull the drawer out to the stop
position.
Lift the front of the drawer up and out
of the wire holder.
Lift the back of the drawer up and out.
www.GEAppliances.com
Slide the control all the way to the
LO setting to provide lower humidity
levels recommended for most fruits.
Set the control to the coldest setting to store
fresh meats.
Set the control to cold to convert the pan
to normal refrigerator temperature and
provide extra vegetable storage space. The
cold air duct is turned off. Variable settings
between these extremes can be selected.
To replace the bottom crisper:
Place the back of the drawer in the
wire holder, making sure the wire
holder fits into the grooves on the back
of the pan.
Lower the front of the drawer into the
wire holder.
Pull the bottom of the wire holder
forward until the wire pops into the
groove located on the bottom of the
drawer.
Pop wire into groove.
11