Disassembly For Repair - Kenwood TK-360G Service Manual

Separating the case assembly from the chassis.
z
1. Remove the two knobs
c
2. Remove the two screws
3. Expand the right and left sides of the bottom of the case
assembly, lift the chassis, and remove it from the case
v
assembly .
c
c
v
4. Taking cure not to cut the speaker lead
case assembly, and pull the speaker lead with connector
TK-360G/(N)/370G/(N)

DISASSEMBLY FOR REPAIR

x
and three round units .
.
TK-360G
z
x
stopper
TK-370G
x
z
x
z
x
b
, open the chassis and
n
.
b
CN3
n
Separating the chassis from the unit.
• TK-360G
1. Remove the twelve small screws
,
large screws .
2. Remove the solder from the antenna terminal using a solder
iron then lift the unit off (X57).
• TK-370G
1. Remove the three screws
Lift the unit (X54), and rise up the connecter lever in the
/
arrow with your finger .
Remove the three hexagonal bosses
m
twelve screws .
2. Remove the solder from the antenna terminal using a
soldering iron, then lift the unit off (X57).
TK-370G
X54-
TK-360G/370G
E, (N)E only Unsolder
X57-
m
, and remove the three
.
.
Ω
, and remove the
Antenna teminal
X57-
17